Jaguar XJ (X350). Service manual — part 1037
•
Moving the transmission selector lever to the ' P' position.
5. Raise and support the vehicle.
Lifting
6. Remove the air deflector (vehicles fitted with diesel engines only).
Air Deflector (76.11.41)
7. Place a suitable container under the transmission fluid filler plug.
8.
WARNING: Make sure that care is exercised near rotating parts. Failure to follow this
instruction may result in personal injury.
With the engine running, remove the transmission fluid filler plug using the special tool.
•
Remove and discard the sealing washer.
9. NOTE:
Use transmission fluid meeting Jaguar specification.
If the transmission fluid does not come out of the transmission fluid filler plug hole the transmission
fluid level is insufficient. If this is the case add the transmission fluid in 0.5 liter units into the
transmission fluid filler plug hole until fluid comes out.
10. NOTE:
Make sure the transmission fluid temperature does not exceed 50°C (122°F). If the transmission
fluid temperature does exceed 50°C (122°F) stop the transmission fluid level check and allow the
transmission fluid to cool until the temperature is below 30°C (86°F).
Allow the transmission fluid to drain from the transmission fluid filler plug hole until the flow almost
stops.
11. Using the special tool, install the transmission fluid filler plug.
•
Install a new sealing washer.
12.
CAUTION: Make sure the transmission fluid filler plug is tightened to the correct
www.
specification. Failure to follow this instruction may result in damage to the vehicle.
Using the special tool and a torque wrench, tighten the transmission fluid filler plug.
•
Tighten the transmission fluid filler plug to the torque given by the calculation.
•
To make sure the transmission filler plug is torqued to the correct specification. Using the
special tool and a torque wrench the following calculation steps must be followed.
Step 1. Multiply 35 Nm by the effective length of the torque wrench (1).
Step 2. Add the effective length of the special tool (2) to the effective length of the torque
wrench (1).
Step 3. Divide the total of step 1 by the total of step 2.
Step 4. Set the torque wrench to the figure arrived at in step 3.
•
Tighten the transmission fluid filler plug to the torque given by the calculation.
13. Remove the container.
14. Install the air deflector (vehicles fitted with diesel engines only).
Air Deflector (76.11.41)
15. Lower the vehicle.
Lifting
16. Disconnect the Jaguar approved diagnostic system.
Description and operation
Transmission Description
The ZF 6HP26 automatic transmission has been developed for vehicles with an engine torque of up to
600 Newton-metres (Nm). This transmission uses planetary gears with hydraulic-electronic control.
The transmission control module (TCM) and the main control valve body units form a composite
element that is installed as a single unit inside the automatic transmission.
The 6HP26 has the following features:
six forward speeds.
a torque converter with an integral converter lock up clutch.
electronic shift and pressure controls.
a single planetary gear set.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст