Jaguar XJ (X350). Service manual — part 1035
Installation
1 . Install the oil temperature sensor.
Install a new O-ring seal.
Tighten to 24 Nm.
2 . Connect the electrical connector.
3 . Install the air deflector.
For additional information, refer to Air Deflector (76.11.41)
4 . Remove the filler cap.
5 . Check and top-up the engine oil.
6 . Install the filler cap.
www.
307 : Automatic Transmission/Transaxle
307-01 : Automatic Transmission/Transaxle
Specifications
Specifications
Fluid Maintenance
CAUTION: Use only Shell M1375.4 Automatic transmission fluid. Use of any
other fluids may result in a transmission malfunction or failure.
Description
Intervals
Normal Maintenance
Not necessary. Filled for life.
Severe Duty Maintenance Change the fluid at 48,000 km (30,000 mile) intervals.
Lubricants, Fluids, Sealers and Adhesives
Description
Specification
Transmission Fluid
Shell M1375.4
Sealant
WSS-M4G323-A6
Metal Surface Cleaner
WSW-M5B392-A
High Temperature Grease Molecote FB180
General Specifications
Engine
Approximate
Liters
Refill Capacity Approximate dry capacity, includes cooler and
tubes. Check the level at normal operating temperature. DO
NOT OVERFILL. If it is necessary to add or change fluid, use
only fluid which has been certified by the supplier as meeting
the Jaguar Cars Ltd specification shown. U.S. Quarts
3.0L
10.0
10.57
3.5L or
4.2L
10.0
10.57
2.7L
10.0
10.57
Diesel
Torque Specifications
Description
Nm
lb-
ft
lb-
in
Converter housing to engine retaining bolts
48 35 -
Transmission mount retaining bolts
50 37 -
Transmission fluid fill plug
A -
-
Transmission control module (TCM) and Main control valve body retaining
screws
8
-
71
Output shaft flange retaining nut
60 44 -
Torque converter retaining bolts
55 41 -
Transmission fluid cooler pipes retaining bolt
23 17 -
Transmission selector cable retaining bolts
11 8
-
Transmission fluid cooler tube to oil pan retaining bolt
10 –
89
Transmission fluid drain plug
8
-
71
Transmission fluid pan, gasket and filter retaining screws
8
-
71
Exhaust manifold retaining nuts (3.0L only)
20 15 -
Dipstick tube retaining bolt (3.0L only)
10 –
89
A = refer to the procedure for correct torque sequence
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст