Jaguar XJ (X350). Service manual — part 1416
![](/vehicle/yohir/vahe/meloningh/mend.png)
C-Pillar Upper Trim Panel
Removal
1 . Remove the rear seat back rest. <<501-10>>
2 . NOTE:
Right-hand shown, left-hand similar.
Detach the rear safety belt.
3 . NOTE:
Left-hand shown, right-hand similar.
Locally detach the door aperture weatherstrip.
4 . NOTE:
Right-hand shown, left-hand similar.
Detach the C-pillar trim panel.
![](/vehicle/yohir/vahe/meloningh/opr.png)
5 . NOTE:
Left-hand shown, right-hand similar.
Remove the C-pillar trim panel.
Cut the C-pillar trim panel retaining strap.
Installation
1
.
WARNING: The retaining strap is a safety critical item and must be
replaced to prevent the trim detaching in the event of the side curtain airbag
deployment.
NOTE:
When installing the new retaining strap and rivet make sure the old clip has been
removed from the body before pressing the trim into place.
www.
![](/vehicle/yohir/vahe/meloningh/yof.png)
To install, reverse the removal procedure.
Tighten to 40 Nm.
![](/vehicle/yohir/vahe/meloningh/byrueltien.png)
Folding Tray (76.47.31)
Removal
1 . Open the folding tray.
2 . Remove the folding tray latch assembly.
3 . Detach the front seat backrest trim panel.
1) Detach the front seat backrest trim panel retaining clips.
2) Detach the front seat backrest trim panel.
4 . Disconnect the rear passenger footwell courtesy lamp electrical connector.
5 . Detach the front seat backrest trim panel retaining strap.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст