Jaguar XJ (X350). Service manual — part 543
6 . Using the special tool, fully install the crankshaft front seal.
Install the crankshaft pulley retaining bolt.
7 .
CAUTION: The crankshaft pulley retaining bolt must not be re-used.
Remove the special tool.
Remove and discard the crankshaft pulley retaining bolt.
8 .
CAUTION: The crankshaft pulley retaining bolt must not be re-used.
CAUTION: The crankshaft pulley retaining bolt must be tighten in two stages.
Install the new crankshaft pulley retaining bolt.
Stage 1: Tighten to 100 Nm.
Stage 2: Tighten to 90 degrees.
9 . Remove the special tool.
10 . Install the special tool.
www.
11 . Install the starter motor.
For additional information, refer to Starter Motor - 2.7L Diesel (86.60.01)
12 . Install the timing belt.
For additional information, refer to Timing Belt
Crankshaft Rear Seal (12.21.20)
Removal
1 . Remove the crankshaft position (CKP) sensor ring.
For additional information, refer to Crankshaft Position (CKP) Sensor Ring
2 . Remove the crankshaft rear seal retaining bolts.
3 . Remove the crankshaft rear seal.
Remove the retaining bolts.
Installation
CAUTION: Make sure the crankshaft rear seal is installed correctly.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст