Jaguar XJ (X350). Service manual — part 542
Crankshaft Front Seal (12.21.14)
Special Service Tools
Locking Tool Flywheel
303-1123
Timing Pin - Automatic Transmission
303-1117
Crankshaft Seal Remover
303-1120
Crankshaft Seal Sleave
303-1122
Crankshaft Seal Installer
303-1121
Removal
1 . Remove the timing belt.
For additional information, refer to Timing Belt
2 . Remove the starter motor.
For additional information, refer to Starter Motor - 2.7L Diesel (86.60.01)
3 . Remove the special tool.
4 . Install the special tool.
5 .
CAUTION: The crankshaft pulley retaining bolt must not be re-used.
Remove the crankshaft pulley.
Remove the retaining bolt.
www.
6 . Install the special tool to the crankshaft.
7 . Using the special tool, remove the crankshaft front seal.
Installation
1
.
CAUTION: Do not use any lubricant on the crankshaft front seal, the special tool or
the crankshaft. Failure to follow this instruction may result in damage to the vehicle.
NOTE:
Make sure all components are clean and dry.
Install a new crankshaft front seal to the special tool.
2 . Reposition the crankshaft front seal along the special tool.
3 . Using the special tool, install the crankshaft front seal to the crankshaft.
4 . Remove the special tool from the crankshaft.
5 . Install the special tool to the crankshaft.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст