Subaru Impreza 3 / Impreza WRX / Impreza WRX STI. Service manual — part 669
SB-21
Rear Seat Belt
SEAT BELT SYSTEM
3. SHOULDER SEAT BELT CENTER AS-
SEMBLY (4 DOOR MODEL)
1) Remove the rear seat. <Ref. to SE-13, REMOV-
2) Remove the rear quarter trim. <Ref. to EI-60,
3) Remove the rear shelf trim. <Ref. to EI-62, RE-
4) Remove the bolts, then remove the shoulder
seat belt assembly.
5) Remove the seat belt lower anchor bolt.
4. CENTER SEAT BELT ASSEMBLY
1) Remove the rear seat cushion.
2) Remove the bolts, then remove the center seat
belt assembly.
B: INSTALLATION
CAUTION:
• During installation, make sure that the seat
belts are not twisted.
• After installation, make sure that the seat
belts are smoothly extended and wound.
• Make sure that the center seat belt is securely
installed.
1) Install each part in the reverse order of removal.
Tightening torque:
Refer to “COMPONENT” of “General Descrip-
tion”. <Ref. to SB-3, REAR SEAT BELT, COM-
2) Turn the seat belt as shown in the figure.
• LH side
SB-00368
SB-00088
SB-00426
SB-00375
SB-22
Rear Seat Belt
SEAT BELT SYSTEM
• RH side (5 door model only)
3) Install the seat cushion and pull out the center
seat belt assembly as follows.
C: INSPECTION
Check for the following, and replace with new parts
if necessary.
• Seat belt is slackened, bent or worn.
• Seat belt is abnormally wound or extended.
• Inner seat belt is deformed or damaged.
• Seat belt buckle cannot be engaged properly.
SB-00379
SB-00452
LIGHTING SYSTEM
LI
Page
General Description . . . . . . . . . . . . . . . . . . . . ...2
Headlight and Tail Light System . . . . . . . . . . . . . . . . 4
Day Time Running Light System . . . . . . . . . . . . . . . . 5
Front Fog Light System . . . . . . . . . . . . . . . . . . . ..6
Turn Signal Light and Hazard Light System . . . . . . . . . . . ...7
Back-up Light System . . . . . . . . . . . . . . . . . . . . 8
Stop Light System . . . . . . . . . . . . . . . . . . . . . ..9
Room Light System . . . . . . . . . . . . . . . . . . . . ..10
Combination Switch (Light) . . . . . . . . . . . . . . . . . ..11
Headlight Beam Leveler System . . . . . . . . . . . . . . . ..13
Combination Base Switch Assembly . . . . . . . . . . . . . . 14
Headlight Assembly . . . . . . . . . . . . . . . . . . . . .15
Headlight Bulb . . . . . . . . . . . . . . . . . . . . . . ..17
Front Turn Signal Light Bulb . . . . . . . . . . . . . . . . . 19
Front Side Marker Light Bulb . . . . . . . . . . . . . . . . ...20
Front Fog Light Assembly . . . . . . . . . . . . . . . . . . 21
Front Fog Light Bulb . . . . . . . . . . . . . . . . . . . . .23
Side Turn Signal Light Assembly . . . . . . . . . . . . . . . .24
Rear Combination Light Assembly . . . . . . . . . . . . . . ...25
Tail/Stop Light Bulb . . . . . . . . . . . . . . . . . . . . ..26
Rear Turn Signal Light Bulb . . . . . . . . . . . . . . . . . .27
Rear Side Marker Light Bulb . . . . . . . . . . . . . . . . . 28
Rear Finisher Light Assembly . . . . . . . . . . . . . . . . ..29
Back-up Light Bulb . . . . . . . . . . . . . . . . . . . . ...30
License Plate Light . . . . . . . . . . . . . . . . . . . . ...31
High-mounted Stop Light . . . . . . . . . . . . . . . . . . .32
Spot Map Light . . . . . . . . . . . . . . . . . . . . . . .33
Room Light . . . . . . . . . . . . . . . . . . . . . . . ...34
Luggage Room Light . . . . . . . . . . . . . . . . . . . . 35
Trunk Room Light . . . . . . . . . . . . . . . . . . . . . .36
Ignition Switch Illumination . . . . . . . . . . . . . . . . . ...37
Day Time Running Resistor . . . . . . . . . . . . . . . . . .39
Reflex Reflector . . . . . . . . . . . . . . . . . . . . . . 40
Door Switch . . . . . . . . . . . . . . . . . . . . . . . ..41
LI-2
General Description
LIGHTING SYSTEM
1. General Description
A: SPECIFICATION
B: CAUTION
• Before disassembling or reassembling parts, always disconnect the battery ground cable from battery.
When replacing the audio, control module and other parts provided with memory functions, record the mem-
ory contents before disconnecting the battery ground cable. Otherwise, the memory is cleared.
• Reassemble the parts in the reverse order of disassembly procedure unless otherwise indicated.
• Connect the connectors securely during reassembly.
• After reassembly, make sure that the functional parts operate normally.
tions for the airbag system in this case. <Ref. to AB-5, CAUTION, General Description.>
• Be careful not to damage the airbag system wiring harness when servicing electrical parts and switches.
Headlight
Low beam (halogen type)
12 V — 55 W
Low beam (HID type)
12 V — 35 W
High beam
12 V — 60 W
Front turn signal/front side marker light
12 V — 27 / 8 W
Front fog light
12 V — 51 W
Side turn signal light
12 V — 1.4 W (LED)
Rear combination light (4 door model)
Tail/stop light
12 V — 5 / 21 W
Turn signal light
12 V — 21 W
Back-up light
12 V — 16 W
Rear combination light (5 door model)
Tail/stop light
12 V — 0.3 W (LED)/12 V — 4.8 W (LED)
Turn signal light
12 V — 21 W
Side marker light
12 V — 5 W
Back-up light (5 door model)
12 V — 21 W
License plate light
12 V — 5 W
High-mounted stop light
4 door model (standard type)
12 V — 21 W
4 door model (with built-in rear spoiler type)
12 V — 1.2 W (LED)
5 door model
12 V — 1.2 W (LED)
Room light
12 V — 8 W
Spot map light
12 V — 8 W
Luggage room light
12 V — 5 W
Trunk room light
12 V — 5 W
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст