Subaru Legacy (2005 year). Service manual — part 944
ET-9
ENTERTAINMENT
Rear Speaker
8. Rear Speaker
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the rear door trim. <Ref. to EI-48, RE-
MOVAL, Door Trim.>
3) Remove the rear speaker mounting screws.
4) Disconnect the harness connector and remove
the rear speaker.
B: INSTALLATION
Install in the reverse order of removal.
ET-00084
ET-10
ENTERTAINMENT
Woofer
9. Woofer
A: REMOVAL
1. SEDAN MODEL
NOTE:
Model with McIntosh audio system only.
1) Disconnect the ground cable from battery.
2) Remove the rear shelf trim. <Ref. to EI-70, RE-
MOVAL, Rear Shelf Trim.>
3) Remove the woofer mounting screws.
4) Disconnect the harness connector and remove
woofer.
2. WAGON MODEL
NOTE:
Model with McIntosh audio system only.
1) Disconnect the ground cable from battery.
2) Remove the hooks (A) and remove the woofer
cover. <Ref. to EI-63, REMOVAL, Rear Quarter
Trim.>
3) Remove the quarter lower trim. <Ref. to EI-63,
REMOVAL, Rear Quarter Trim.>
4) Remove the woofer bracket mounting clip (A)
and screws, and then remove the woofer bracket.
5) Disconnect the harness connector and remove
the woofer.
B: INSTALLATION
Install in the reverse order of removal.
ET-00085
(A)
(A)
ET-00086
ET-00106
(A)
ET-11
ENTERTAINMENT
Power Amplifier
10.Power Amplifier
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the passenger’s seat. <Ref. to SE-7,
REMOVAL, Front Seat.>
3) Disconnect the harness connector.
4) Remove the nuts to remove power amplifier.
B: INSTALLATION
Install in the reverse order of removal.
ET-00165
ET-12
ENTERTAINMENT
Antenna
11.Antenna
A: INSPECTION
Measure the resistance between antenna terminal
and each antenna wire.
If an antenna wire is OK, resistance will be less
than 1
Ω. If an antenna wire is broken, resistance
will be more than 1 M
Ω.
NOTE:
When checking the continuity, wind a piece of alu-
minum foil around the tip of tester probe and press
the foil against wire with your finger.
To locate the broken point, move the probe along
antenna wire.
B: REPAIR
1) Clean the antenna wire and surrounding area
with a cloth dampened by alcohol.
2) Paste a thin masking film on the glass along bro-
ken wire.
3) Apply conductive silver composition (DUPONT
No. 4817) on the broken portion with a drawing
pen.
4) Dry out the deposited portion.
5) After repair has been completed, measure the
resistance in repaired wire.
(A) Tester probe
(B) Aluminum foil
(C) Antenna wire
ET-00007
(B)
(C)
(A)
ET-00008
(A) Broken portion
(B) Masking film
(C) Conductive silver composition
ET-00009
(B)
(C)
(A)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст