Subaru Legacy (2005 year). Service manual — part 931
LI-21
LIGHTING SYSTEM
Front Fog Light Assembly
16.Front Fog Light Assembly
A: REMOVAL
1. EXCEPT FOR OUTBACK MODEL
1) Disconnect the ground cable from battery.
2) Remove the front fog light cover (A).
3) Disengage the two clips, and then turn over the
lower mud guard.
4) Disconnect the harness connector.
5) Remove the mounting bolts, and then detach the
fog light assembly by pulling it.
2. OUTBACK MODEL
1) Disconnect the ground cable from battery.
2) Remove the two clips, and then turn over the
lower mud guard.
3) Disconnect the harness connector.
4) Remove the mounting bolts, and then detach the
fog light assembly by pulling it.
B: INSTALLATION
Install in the reverse order of removal.
CAUTION:
When installing the fog light assembly, be sure
to secure the upper hock.
LI-00287
(A)
LI-00288
LI-00289
LI-00288
LI-00325
LI-00326
LI-22
LIGHTING SYSTEM
Front Fog Light Bulb
17.Front Fog Light Bulb
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the two clips, and then turn over the
lower mud guard.
3) Disconnect the harness connector.
4) Remove the back cover.
5) Remove the spring retainer then detach the fog
light bulb.
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
1) Visually check the bulb for blow out.
2) Check the bulb specification. <Ref. to LI-2,
SPECIFICATION, General Description.>
3) If NG, replace the bulb with a new one.
LI-00288
LI-00291
LI-23
LIGHTING SYSTEM
Rear Fog Light
18.Rear Fog Light
A: REMOVAL
NOTE:
Rear fog light is installed to rear combination light
of driver’s side for sedan and rear gate garnish of
driver’s side for wagon.
1. SEDAN MODEL
Remove the rear combination light. <Ref. to LI-25,
REMOVAL, Rear Combination Light Assembly.>
2. WAGON MODEL
1) Remove the rear gate trim. <Ref. to EI-69, RE-
MOVAL, Rear Gate Trim.>
2) Disconnect the harness connectors and remove
the rear gate garnish. <Ref. to EI-76, REMOVAL,
Rear Gate Garnish.>
3) Remove the mounting nuts and detach the rear
fog light assembly.
B: INSTALLATION
Install in the reverse order of removal.
LI-00292
LI-24
LIGHTING SYSTEM
Side Turn Signal Light Assembly
19.Side Turn Signal Light As-
sembly
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the scalp caps. <Ref. to GW-18, RE-
PLACEMENT, Scalp Cap.>
3) Remove the mirror. <Ref. to GW-21, REPLACE-
MENT, Outer Mirror.>
4) Disconnect the harness connector, remove the 3
mounting screws and then remove the side turn
signal light assembly.
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
1) Install the side turn signal light assembly and
check that it blinks normally.
2) If it does not blink normally, replace the side turn
signal light assembly with a new one.
NOTE:
Since LED (Light Emitting Diode) is used for side
turn signal light, replace the side turn signal light
assembly when the LED is powered off.
LI-00293
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст