Subaru Legacy IV (2008 year). Service manual — part 47
EC(H4SO)-10
Fuel Temperature Sensor
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)
8. Fuel Temperature Sensor
A: REMOVAL
The fuel temperature sensor is integrated into fuel
level sensor as one unit; therefore, refer to “Fuel
Level Sensor” for removal procedure. <Ref. to
FU(H4SO)-57, REMOVAL, Fuel Level Sensor.>
B: INSTALLATION
The fuel temperature sensor and fuel level sensor
are integrated into one unit; therefore, refer to “Fuel
Level Sensor” for installation procedure. <Ref. to
FU(H4SO)-57, INSTALLATION, Fuel Level Sen-
sor.>
EC(H4SO)-11
Fuel Sub Level Sensor
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)
9. Fuel Sub Level Sensor
A: REMOVAL
For removal procedures, refer to “FU” section.
<Ref. to FU(H4SO)-58, REMOVAL, Fuel Sub Level
Sensor.>
B: INSTALLATION
For installation procedures, refer to “FU” section.
<Ref. to FU(H4SO)-59, INSTALLATION, Fuel Sub
Level Sensor.>
EC(H4SO)-12
Fuel Tank Pressure Sensor
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)
10.Fuel Tank Pressure Sensor
A: REMOVAL
WARNING:
Place “NO OPEN FLAMES” signs near the
working area.
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Open the fuel filler lid, and remove the fuel filler
cap.
4) Lift up the vehicle.
5) Disconnect the connector from the fuel tank
pressure sensor.
6) Disconnect the pressure hose from the fuel tank
pressure sensor.
7) Remove the fuel tank pressure sensor along
with the bracket.
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
7.4 N·m (0.8 kgf-m, 5.5 ft-lb)
C: INSPECTION
Make sure the hoses are not cracked or loose.
IN-00203
EC-02084
EC-02084
EC(H4SO)-13
Pressure Control Solenoid Valve
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)
11.Pressure Control Solenoid
Valve
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Lift up the vehicle.
4) Disconnect connector (A) from the pressure con-
trol solenoid valve.
5) Disconnect the evaporation hose (B) from the
pressure control solenoid valve.
6) Remove the bolts (C) which secure the bracket
to the fuel tank.
7) Remove the pressure control solenoid valve and
bracket as a unit.
8) Remove the pressure control solenoid valve
from the bracket.
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
7.35 N·m (0.7 kgf-m, 5.4 ft-lb)
C: INSPECTION
Make sure the hoses are not cracked or loose.
IN-00203
(C)
(B)
EC-02086
(B)
(A)
EC-02087
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст