Subaru Legacy IV (2008 year). Service manual — part 46
EC(H4SO)-6
Canister
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Check that there is no damage or dust on the quick
connector. If necessary, clean the seal surface of
the pipe.
Tightening torque:
8 N·m (0.8 kgf-m, 5.9 ft-lb)
C: INSPECTION
Make sure the canister and canister hoses are not
cracked or loose.
EC-02080
EC(H4SO)-7
Purge Control Solenoid Valve
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)
5. Purge Control Solenoid Valve
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Disconnect the connector and evaporation hos-
es of purge control solenoid valve, and then re-
move the purge control solenoid valve.
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque (Purge control solenoid
valve attachment bolt):
19 N·m (1.9 kgf-m, 14.0 ft-lb)
NOTE:
Connect the evaporation hose as shown in the fig-
ure.
C: INSPECTION
Make sure the hoses are not cracked or loose.
IN-00203
EC-02392
(A) To fuel pipe (intake manifold)
(B) To fuel pipe (evaporation line)
EC-02392
(B)
(A)
EC-02289
EC(H4SO)-8
EGR Valve
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)
6. EGR Valve
A: REMOVAL
For removal procedures, refer to “FU” section.
<Ref. to FU(H4SO)-29, REMOVAL, EGR Valve.>
B: INSTALLATION
For installation procedures, refer to “FU” section.
<Ref. to FU(H4SO)-29, INSTALLATION, EGR
Valve.>
EC(H4SO)-9
Fuel Level Sensor
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)
7. Fuel Level Sensor
A: REMOVAL
For removal procedures, refer to “FU” section.
<Ref. to FU(H4SO)-57, REMOVAL, Fuel Level
Sensor.>
B: INSTALLATION
For installation procedures, refer to “FU” section.
<Ref. to FU(H4SO)-57, INSTALLATION, Fuel Lev-
el Sensor.>
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст