Subaru Legacy IV (2008 year). Service manual — part 246
EC(H4DOTC)-4
General Description
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)
C: PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION
TOOL NUMBER
DESCRIPTION
REMARKS
18353AA000
CLAMP PLIER
• Used for removing and installing the PCV
hose.
• This is a general tool made by the French
company CAILLAU. (code) 54.0.000.205
To make this easier to obtain, it has been pro-
vided with a tool number.
ST18353AA000
EC(H4DOTC)-5
Front Catalytic Converter
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)
2. Front Catalytic Converter
A: REMOVAL
The front catalytic converter is integrated into the
center exhaust pipe (front). Refer to “Center Ex-
haust Pipe” for removal procedures.
<Ref. to EX(H4DOTC)-7, REMOVAL, Center Ex-
haust Pipe.>
B: INSTALLATION
The front catalytic converter is integrated into the
center exhaust pipe (front). Refer to “Center Ex-
haust Pipe” for installation procedures.
<Ref. to EX(H4DOTC)-9, INSTALLATION, Center
Exhaust Pipe.>
C: INSPECTION
1) Check the connections and welds for exhaust
leaks.
2) Make sure there are no holes or rusting.
EC(H4DOTC)-6
Rear Catalytic Converter
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)
3. Rear Catalytic Converter
A: REMOVAL
The rear catalytic converter is integrated into the
center exhaust pipe (rear). Refer to “Center Ex-
haust Pipe” for removal procedures.
<Ref. to EX(H4DOTC)-7, REMOVAL, Center Ex-
haust Pipe.>
B: INSTALLATION
The rear catalytic converter is integrated into the
center exhaust pipe (rear). Refer to “Center Ex-
haust Pipe” for installation procedures.
<Ref. to EX(H4DOTC)-9, INSTALLATION, Center
Exhaust Pipe.>
C: INSPECTION
1) Check the connections and welds for exhaust
leaks.
2) Make sure there are no holes or rusting.
EC(H4DOTC)-7
Canister
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)
4. Canister
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Lift up the vehicle.
4) Remove the rear wheel LH.
5) Remove the rear mud guard LH. <Ref. to EI-29,
REAR MUD GUARD, REMOVAL, Mud Guard.>
6) Disconnect quick connector (A).
7) Disconnect the drain valve connector (B).
8) Remove clip (C).
9) Remove the canister from body.
IN-00203
EC-02079
(A)
(A)
(C)
(B)
EC-02080
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст