Subaru Legacy IV (2008 year). Service manual — part 472
ME(H6DO)-14
General Description
MECHANICAL
8. ENGINE MOUNTING
(1)
Front cushion rubber
Tightening torque:N·m (kgf-m, ft-lb)
T1: 35 (3.6, 25.8)
T2: 85 (8.7, 62.7)
(1)
T2
T1
T1
T2
ME-00445
ME(H6DO)-15
General Description
MECHANICAL
C: CAUTION
• Wear appropriate work clothing, including a cap, protective goggles and protective shoes when performing
any work.
• Remove contamination including dirt and corrosion before removal, installation or disassembly.
• Keep the disassembled parts in order and protect them from dust and dirt.
• Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, in-
stallation, disassembly and replacement.
• Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.
• Be sure to tighten fasteners including bolts and nuts to the specified torque.
• Place shop jacks or rigid racks at the specified points.
• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from the bat-
tery.
• All parts should be thoroughly cleaned, paying special attention to engine oil passages, pistons and bear-
ings.
• Rotating parts and sliding parts such as piston, bearing and gear should be coated with oil prior to assem-
bly.
• All removed parts, if to be reused, should be reinstalled in the original positions and directions.
• Bolts, nuts and washers should be replaced with new parts as required.
• Even if necessary inspections have been made in advance, proceed with assembly work while making re-
checks.
• Remove or install the engine in an area where chain hoists, lifting devices, etc. are available for ready use.
• Be sure not to damage coated surfaces of body panels with tools, or not to stain seats and windows with
coolant or oil. Place a cover over fender, as required, for protection.
• Prior to starting work, prepare the following:
Service tools, clean cloth, containers to catch coolant and oil, wire ropes, chain hoist, transmission jacks, etc.
• Lift up or lower the vehicle when necessary. Make sure to support the correct positions.
ME(H6DO)-16
General Description
MECHANICAL
D: PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION
TOOL NUMBER
DESCRIPTION
REMARKS
18250AA010
CYLINDER HEAD
TABLE
• Used for replacing valve guides.
• Used for removing and installing valve spring.
18232AA000
ENGINE STAND
Used for disassembling and assembling engine.
498497100
CRANKSHAFT
STOPPER
Used for removing and installing the drive plate.
18254AA000
PISTON GUIDE
Used for installing piston in cylinder.
ST18250AA010
ST18232AA000
ST-498497100
ST18254AA000
ME(H6DO)-17
General Description
MECHANICAL
499585500
VALVE OIL SEAL
GUIDE
Used for press-fitting of intake and exhaust
valve guide oil seals.
18253AA000
PISTON PIN GUIDE
Used for installing piston pin, piston and con-
necting rod.
18350AA000
CONNECTING ROD
BUSHING
REMOVER AND
INSTALLER
Used for removing and installing connecting rod
bushing.
499097700
PISTON PIN
REMOVER ASSY
Used for removing piston pin.
499977500
CAM SPROCKET
WRENCH
Used for removing and installing intake cam
sprocket.
ILLUSTRATION
TOOL NUMBER
DESCRIPTION
REMARKS
ST-499585500
ST18253AA000
ST18350AA000
ST-499097700
ST-499977500
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст