Subaru Legacy III (2000-2003 year). Service manual — part 292
SP(H6DO)-8
SPEED CONTROL SYSTEMS
ACCELERATOR CONTROL CABLE
3. Accelerator Control Cable
A: REMOVAL
1) Remove accelerator pedal. <Ref. to SP(H6DO)-
4, REMOVAL, Accelerator Pedal.>
2) Separate accelerator cable and accelerator ped-
al.
B: INSTALLATION
1) Install in the reverse order of removal.
2) Apply grease to engine side accelerator cable
end.
Grease:
Part No. 004404002
Slicolube G-30M
NOTE:
• If cable clamp is damaged, replace it with a new
one.
• Never fail to cover outer cable end with boot.
• Be careful not to kink accelerator cable.
• Do not apply grease to the throttle cable on the
engine side.
3) Adjustment after pedal installation <Ref. to
SP(H6DO)-7, ADJUSTMENT, Accelerator Pedal.>
C: INSPECTION
1) Make sure the inner cable is not twisted or
frayed.
2) Make sure the outer cable is not cracked.
(A) Grease application area
(B) Throttle cam
SP-00042
( A )
( B )
IGNITION
IG(H6DO)
Page
General Description . . . . . . . . . . . . . . . . . . . . . 2
Spark Plug. . . . . . . . . . . . . . . . . . . . . . . . ...4
Ignition Coil and Ignitor Assembly . . . . . . . . . . . . . . . ...7
IG(H6DO)-2
IGNITION
GENERAL DESCRIPTION
1. General Description
A: SPECIFICATIONS
B: COMPONENT
Item
Designation
Ignition coil and
ignitor assembly
Model
FK0140
Manufacturer
DIAMOND
Spark plug
Type and manufacturer
NGK : PLFR6A-11
Thread size
mm
14, P = 1.25
Spark gap
mm (in)
1.0 — 1.1 (0.039 — 0.043)
(1) Spark plug
Tightening torque: N·m (kgf-m, ft-lb)
(2) Ignition coil and ignitor ASSY
T1: 16 (1.6, 12)
T2: 21 (2.1, 15)
IG-00052
( 1 )
( 1 )
( 2 )
( 2 )
T1
T2
T2
T1
IG(H6DO)-3
IGNITION
GENERAL DESCRIPTION
C: CAUTION
• Wear working clothing, including a cap, protec-
tive goggles, and protective shoes during opera-
tion.
• Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust or dirt.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly, and replacement.
• Be careful not to burn your hands, because each
part on the vehicle is hot after running.
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or safety stands at the specified
points.
• Before disconnecting electrical connectors of
sensors or units, be sure to disconnect ground ca-
ble from battery.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст