Subaru Legacy III (2000-2003 year). Service manual — part 865
AC-48
HVAC SYSTEM (HEATER, VENTILATOR AND A/C)
SUNLOAD SENSOR (AUTO A/C)
21.Sunload Sensor (Auto A/C)
A: REMOVAL
1) Disconnect ground cable from battery.
2) Insert a slotted screwdriver to remove sunload
sensor.
3) Disconnect sunload sensor connector.
NOTE:
Be careful not to damage sensors and interior trims
when removing them.
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
<Ref. to AC-56, DTC 25 OR –25 (SUNLOAD SEN-
SOR), Diagnostic Procedure with Diagnostic Trou-
ble Code (DTC) (LHD Model).>
<Ref. to AC-70, DTC 25 OR –25 (SUNLOAD SEN-
SOR), Diagnostic Procedure with Diagnostic Trou-
ble Code (DTC) (RHD Model).>
AC-00308
( A )
AC-00337
AC-49
HVAC SYSTEM (HEATER, VENTILATOR AND A/C)
AIR VENT GRILLE
22.Air Vent Grille
A: REMOVAL
1. AIR VENT GRILLE DRIVER SIDE
1) Disconnect ground cable from battery.
2) Set tilt steering to the lowest position.
3) Disconnect each electrical connector to remove
front cover (A) and switch panel (B).
4) Loosen screw (C) to remove center panel (D).
5) Remove meter visor (E).
6) Loosen screws to remove grille.
2. AIR VENT GRILLE PASSENGER SIDE
1) Remove grille using sharp-edged screwdriver.
NOTE:
Wrap screwdriver with vinyl tape to prevent dam-
age to interior parts.
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
The direction and amount of air should be adjusted
smoothly.
The adjustment should be kept in each position.
(1) Hook pawl
AC-00338
:
( A )
( B )
( C )
( D )
( E )
( 1 )
AC-00339
AC-00340
AC-50
HVAC SYSTEM (HEATER, VENTILATOR AND A/C)
HEATER DUCT
23.Heater Duct
A: REMOVAL
1) Remove heater unit. <Ref. to AC-30, REMOV-
AL, Heater Unit.>
2) Remove front seat. <Ref. to SE-7, REMOVAL,
Front Seat.>
3) Remove front side sill cover.
4) Pull off floor mat to remove heater duct.
B: INSTALLATION
Install in the reverse order of removal.
AC-00341
AC-51
HVAC SYSTEM (HEATER, VENTILATOR AND A/C)
HEATER VENT DUCT
24.Heater Vent Duct
A: REMOVAL
1) Remove instrument panel. <Ref. to EI-35, RE-
MOVAL, Instrument Panel Assembly.>
2) Remove nine screws.
3) Remove heater vent duct.
B: INSTALLATION
Install in the reverse order of removal.
AC-00342
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст