Opel Frontera UBS. Service manual — part 1923
3D – 4 REAR SUSPENSION; COIL SPRING
INSTALLATION
5. Coil Spring
Make sure that the coil spring is installed in the proper
position.
REMOVAL
Preparation:
1)
Raise the vehicle and support the frame with suitable
safety stands.
2)
Support the rear axle case with a jack.
1. Parking Brake Cable Bracket
Remove the parking brake cable from the trailing link.
2. Stabilizer Bar
Disconnect the stabilizer bar at the stabilizer link.
3. Shock Absorber
Remove the shock absorber from the axle case.
4. Insulator
5. Coil Spring
Remove the insulator and coil spring while lowering
the rear axle case.
CAUTION:
Be sure not to let the brake hose, parking brake cable,
and breather hose extend to their full length.
INSPECTION AND REPAIR
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
•
Coil spring
•
Insulator
Fit the end of the coil spring to the coil spring seat and
mount the coil spring on the rear axle case.
REAR SUSPENSION; COIL SPRING 3D – 5
4. Insulator
Install the insulator on the coil spring. Jack up the axle
case gently with the top of the coil spring to set the
spring seat on the frame side.
3. Shock Absorber
Tighten the nut lightly, and retighten to the specified
torque after the vehicle is at curb height.
NOTE:
When mounting shock absorber, be sure not to use
grease on bushings or any other nearby part.
Shock Absorber Nut Torque
N·m (kg·m/lb·ft)
78 (8.0 / 58)
2. Stabilizer Bar
Stabilizer Bar Nut Torque
N·m (kg·m/lb·ft)
50 (5.1 / 37)
1. Parking Brake Cable Bracket
3D – 6 REAR SUSPENSION; COIL SPRING
SHOCK ABSORBER
1
3
2
Removal Steps
1.
Nut and washer
2.
Bolt, nut and washer
3.
Shock absorber
Installation Steps
3.
Shock absorber
2.
Bolt, nut and washer
1.
Nut and washer
461RW003
REAR SUSPENSION; COIL SPRING 3D – 7
REMOVAL
1. Nut and Washer
2. Bolt, Nut and Washer
3. Shock Absorber
INSPECTION AND REPAIR
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
•
Shock absorber
•
Rubber bushing (Axle side)
INSTALLATION
3. Shock Absorber
NOTE:
When mounting rubber bushings, be sure not to use
grease on bushings or any other nearby part.
2. Bolt, Nut and Washer
NOTE:
Tighten the bolt and nut lightly, and retighten to the
specified torque after the vehicle is at curb height.
Shock Absorber Nut Torque
N·m (kg·m/lb·ft)
95 (9.7 / 70)
1. Nut and Washer
NOTE:
Tighten the bolt and nut lightly, and retighten to the
specified torque after the vehicle is at curb height.
Shock Absorber Nut Torque
N·m (kg·m/lb·ft)
78 (8.0 / 58)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст