Opel Frontera UBS. Service manual — part 1924
3D – 8 REAR SUSPENSION; COIL SPRING
TRAILING LINK
2
3
2
1
Removal Steps
1.
Parking brake cable
2.
Bolt and nut
3.
Trailing link
Installation Steps
3.
Trailing link
2.
Bolt and nut
1.
Parking brake cable
REMOVAL
1. Parking Brake Cable
Remove the parking brake cable from the trailing link.
2. Bolt and Nut
3. Trailing Link
460RW025
REAR SUSPENSION; COIL SPRING 3D – 9
INSPECTION AND REPAIR
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
1. Trailing Link
2. Rubber Bushing
Remove the rubber bushing.
Remover: 5-8840-2298-0 (J-39214)
Install the rubber bushing.
Installer: 5-8840-2298-0 (J-39214)
NOTE:
When mounting rubber bushings, be sure not to use
grease on bushings or any other nearby part.
INSTALLATION
3. Trailing Link
Make sure that the trailing link is in its correct
position.
NOTE:
When mounting trailing link, be sure not to use
grease on bushings or any other nearby part.
2. Bolt and Nut
NOTE:
Tighten the bolts and nuts lightly, and retighten to
the specified torque after the vehicle is at curb height.
Trailing Link Nut Torque
N·m (kg·m/lb·ft)
137 (14.0 / 101)
1. Parking Brake Cable
CAUTION:
The parking brake cable should not be overstrained or
slackened.
3D – 10 REAR SUSPENSION; COIL SPRING
CENTER LINK
3
3
4
1
2
Removal Steps
1.
Speed sensor cable
(If equipped with ABS)
2.
Speed sensor cable bracket
(If equipped with ABS)
3.
Bolt and nut
4.
Center link
Installation Steps
4.
Center link
3.
Bolt and nut
2.
Speed sensor cable bracket
(If equipped with ABS)
1.
Speed sensor cable
(If equipped with ABS)
REMOVAL
1. Speed Sensor Cable (If equipped with ABS)
Remove the speed sensor cable from the center link.
2. Speed Sensor Cable Bracket (If equipped with ABS)
Remove the speed sensor cable bracket from the
frame.
3. Bolt and Nut
4. Center Link
460RW026
REAR SUSPENSION; COIL SPRING 3D – 11
INSPECTION AND REPAIR
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
1. Center Link
2. Rubber Bushing
Remove the rubber bushing.
Remover: 5-8840-2298-0 (J-39214)
Install the rubber bushing.
Installer: 5-8840-2298-0 (J-39214)
NOTE:
When mounting rubber bushings, be sure not to use
grease on bushings or any other nearby part.
INSTALLATION
4. Center Link
Make sure that the center link is in its correct position.
NOTE:
When mounting center link, be sure not to use grease
on bushings or any other nearby part.
3. Bolt and Nut
NOTE:
Tighten the bolts and nuts lightly, and retighten to
the specified torque after the vehicle is at curb height.
Center Link Nut Torque
N·m (kg·m/lb·ft)
137 (14.0 / 101)
2. Speed Sensor Cable Bracket
1. Speed Sensor Cable
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст