Opel Frontera UBS. Service manual — part 2873
8F–86
BODY STRUCTURE
Tailgate Main Weatherstrip
Parts Location
682RS005
Legend
(1) Tailgate Main Weatherstrip
Removal
1. Remove tailgate main weatherstrip.
D
Pull the tailgate main weatherstrip out from the
body panel.
Installation
1. Install the tailgate main weatherstrip.
D
Align the A and B positions to the corners of the
body panel. Install the tailgate main weatherstrip to
the body panel by gently tapping with a plastic
hammer. There should be not clearance between
the body panel the tailgate main weatherstrip.
8F–87
BODY STRUCTURE
Spare Tire Carrier
Parts Location
530RS001
Legend
(1) Spare Tire
(2) Spare Tire Carrier
Removal
1. Remove spare tire.
2. Remove spare tire carrier.
D
Remove the special bolts by using special tool (If so
equipped).
D
Spare tire carrier bolt wrench 5–8840–2095–0
(J–34355).
530RS002
Installation
1. Install the spare tire carrier.
D
Tighten the carrier fixing bolts to the specified
torque.
Torque : 31 N
•
m (3.2kg·m/23 lb ft)
2. Install the spare tire.
D
Tighten the spare tire fixing bolts to the specified
torque.
Torque : 118 N
•
m (12.0kg·m/87 lb ft)
8F–88
BODY STRUCTURE
Headlining
Parts Location
666RW003
Legend
(1) Clip
(2) Interior Trim Panels
(3) Sun Roof Finisher (W/Sun Roof)
(4) Headlining
(5) Dome Light
(6) Sunvisors
(7) Map Light
(8) Sunvisor Holder
(9) Rear View Mirror
(10) Multi Meter
Removal
1. Disconnect the battery ground cable.
2. Remove interior trim panels.
D
Refer to the Exterior / Interior Trim section.
3. Remove dome light.
D
Remove the dome light lens and the fixing screws.
D
Disconnect the dome light connectors.
4. Remove multi meter (4) (If so equipped).
D
Remove two caps (2), two screws (3) and
disconnect the connector (1).
821RW241
8F–89
BODY STRUCTURE
5. Remove rear view mirror.
D
Remove the rubber stopper (1).
D
Pry off the mirror stay cover (2) and remove 3
screws.
720RW004
6. Remove map light/sun roof switch.
D
Pry the map light clip free from the map light/sun
roof switch bracket and disconnect the connector.
805RS001
7. Remove sunvisors.
D
Remove the fixing screw and turn the sunvisor
holder (1) to remove it.
D
Disconnect the vanity mirror illumination connector.
743RW008
8. Remove sun roof finisher (W/Sun roof).
9. Remove headlining.
D
Remove the headlining fixing clips.
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Install the headlining so that the fixing clips will not
come off.
2. To install the sun roof finisher (3), first fit in at one
place with the head lining (2) close to the sun roof
frame complete (1), then install the entire finisher
tightly by hitting it with a plastic hammer, not allowing
it to move up.
665RS001
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст