Opel Frontera UBS. Service manual — part 2869
![](/vehicle/goneen/quin/cui/helononovyor.png)
8F–70
BODY STRUCTURE
D
Carefully remove the weatherstrip (2) from the door
panel.
631RW003
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Apply soapy water to the door frame groove when
installing the front door weather strip (2).
2. Apply the sealing adhesive (3) to the upper A portion
of the door frame (1) and press it for installation after
assembling the weatherstrip (2).
631RS013
3. After positioning the weatherstrip (4) corner, insert
the weatherstrip into the door frame groove from A
point in the arrow–marked direction.
4. Insert the weatherstrip clip (5) into the door panel up
to its base.
631RW009
![](/vehicle/goneen/quin/cui/gevey.png)
8F–71
BODY STRUCTURE
Rear Door Weatherstrip
Parts Location
655RW010
Legend
(1) Check Arm Pin
(2) Rear Door Weather Strip
(3) Clip
Removal and Installation
Refer to Front Door Weatherstrip in this section.
![](/vehicle/goneen/quin/cui/veser.png)
8F–72
BODY STRUCTURE
Front Door Seal Finisher
Parts Location
635RS002
Legend
(1) Front Door Sill Plate
(2) Front Door Seal Finisher
Removal
1. Disconnect the battery ground cable.
2. Remove front door sill plate.
3. Remove front door seal finisher (1).
D
Pull the finisher out from the body panel.
635RS003
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Insert the finisher into the A corner and install the
finisher (2) in the arrow–marked directions.
2. Take care not to allow the sill plate (1) to distort or twist
the finisher.
635RS002
![](/vehicle/goneen/quin/cui/who.png)
8F–73
BODY STRUCTURE
Rear Door Seal Finisher
Parts Location
655RS002
Legend
(1) Rear Door Sill Plate and Luggage Side Lower
Cover
(2) Rear Door Seal Finisher
Removal
1. Disconnect the battery ground cable.
2. Remove rear door sill plate and the luggage side
lower cover.
3. Remove rear door seal finisher (1).
D
Pull the rear door seal finisher (1) out from the body
panel.
635RS003
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Insert the rear door seal finisher (2) into the A corner
and install the finisher in the arrow-marked directions.
2. Be careful not to allow the sill plate and cover (1) to
distort or twist the finisher.
655RS002
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст