Isuzu Rodeo UE. Service manual — part 534
8B–4
WIPER/WASHER SYSTEM
Windshield Washer Spray Pattern
880RW005
Legend
(1) Spray Target
(2) Washer Nozzle
WIPER/WASHER SYSTEM
8B–5
Windshield Wiper Linkage
Windshield Wiper Linkage and Associated Parts
880RW004
Legend
(1) Windshield Wiper Arm/Blade
(2) Vent Cowl Cover
(3) Windshield Wiper Linkage Assembly
(4) Windshield Wiper Motor
Removal
1. Disconnect the battery ground cable.
2. Remove the windshield wiper arm/blade.
3. Remove the vent cowl cover.
4. Remove the windshield wiper motor.
5. Remove the pivot assembly mounting nuts, fixing
screws.
6. Take out the windshield wiper linkage assembly from
the opening of the cowl.
Installation
To install, follow the removal steps in the reverse order.
8B–6
WIPER/WASHER SYSTEM
Windshield Wiper Arm/Blade
Removal
1. Dry the cap(2) off with the tip of a screwdriver.
2. Remove the nut.
3. Remove the wiper arm/blade(1).
880RW003
Installation
To install, follow the removal steps in the reverse order,
noting the following points:
880RW006
1. Before installing the wiper arm/blade to the shaft,
confirm that the motor stops at the autostop position.
2. Set the wiper arm/blade so that the tips of both blades
are positioned about 40 mm (1.57 in) from the upper
edge of the cowl cover as shown in the figure.
3. Tighten the nuts to the specified torque.
Torque: 23 N·m (17 lb ft)
WIPER/WASHER SYSTEM
8B–7
Windshield Wiper Blade Rubber
Removal
1. Push the wiper blade lock(1) while pulling the wiper
blade in the arrow direction as shown in the figure.
CAUTION: When the wiper blade has been
removed, wrap the tip of the wiper arm with cloth, to
avoid damaging the glass.
880RS011
2. Pull the end of rubber and remove the projection(3)
from the click of the blade stay (2).
880RS010
3. Pull the rubber out in the same direction.
Installation
To install, follow the removal steps in the reverse order,
noting the following points:
1. Install the click of the blade stay in the groove of the
new rubber and slide it in. Complete wiper blade
installation by pushing the click.
885RS002
2. Finally, check that the click of the stay has caught in
the hole of the rubber.
885RS001
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст