Infiniti G20 (P11). Manual — part 125
NCBR0111
CAUTION:
Be careful not to damage sensor edge and sensor rotor teeth.
When removing the front or rear wheel hub assembly, first
remove the ABS wheel sensor from the assembly. Failure to
do so may result in damage to the sensor wires making the
sensor inoperative.
Front Wheel Sensors
NCBR0111S01
SBR472E
GI
MA
EM
LC
EC
FE
CL
MT
AT
AX
SU
ST
RS
BT
HA
SC
EL
IDX
REMOVAL AND INSTALLATION
ABS
BR-75
Rear Wheel Sensors
NCBR0111S09
SBR473E
REMOVAL AND INSTALLATION
ABS
Rear Wheel Sensors
BR-76
ABS Actuator and Electric Unit
NCBR0111S10
SBR474E
REMOVAL
NCBR0111S1001
1.
Disconnect battery cable.
2.
Drain brake fluid.
3.
Remove mounting bracket fixing bolts and nuts.
4.
Disconnect connector, brake pipes and remove fixing nuts.
INSTALLATION
NCBR0111S1002
CAUTION:
After installation, refill brake fluid. Then bleed air.
1.
Connect brake pipes temporarily.
2.
Tighten fixing bolts and nuts.
3.
Tighten brake pipes.
4.
Connect connector and battery cable.
GI
MA
EM
LC
EC
FE
CL
MT
AT
AX
SU
ST
RS
BT
HA
SC
EL
IDX
REMOVAL AND INSTALLATION
ABS
ABS Actuator and Electric Unit
BR-77
SBR984C
SBR873CA
Sensor Rotor
NCBR0111S02
REMOVAL
NCBR0111S0201
1.
Remove the drive shaft and rear wheel hub. Refer to “Drive
Shaft” and “Wheel Hub” in AX section.
2.
Remove the sensor rotor using suitable puller, drift and bear-
ing replacer.
SBR985C
INSTALLATION
NCBR0111S0202
Install the sensor rotor. For front sensor rotor, use hammer and
wooden block. For rear sensor rotor, use suitable drift and press.
I
Always replace sensor rotor with new one.
SBR986C
I
Pay attention to the dimension of rear sensor rotor as show in
figure.
h: 22.7 - 23.7 mm (0.894 - 0.933 in)
REMOVAL AND INSTALLATION
ABS
Sensor Rotor
BR-78
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст