Infiniti G20 (P11). Manual — part 137
Removal and Installation
NCBT0015
I
When removing or installing the seat trim, carefully handle it to keep dirt out and avoid damage.
FOLDING SEAT
NCBT0015S01
SBT890
GI
MA
EM
LC
EC
FE
CL
MT
AT
AX
SU
BR
ST
RS
HA
SC
EL
IDX
REAR SEAT
Removal and Installation
BT-43
Adjustment
NCBT0016
Install motor & limit SW assembly and sunroof rail assembly in the following sequence:
1. Arrange equal lengths of link and wire assemblies on both sides of sunroof opening.
2. Connect sunroof connector to sunroof switch and positive (+) power supply.
3. Set lid assembly to fully closed position
by operating OPEN switch and TILT switch.
4. Fit outer side of lid assembly to the surface of roof on body outer panel.
5. Remove motor, and keep OPEN switch pressed until motor pinion gear reaches the end of its rotating
range.
6. Install motor.
7. Check that motor drive gear fits properly in wires.
8. Press TILT-UP switch to check lid assembly for normal tilting.
9. Check sunroof lid assembly for normal operations (tilt-up, tilt-down, open, and close).
SBF920F
SUNROOF
Adjustment
BT-44
Removal and Installation
=NCBT0017
I
After any adjustment, check sunroof operation and lid align-
ment.
I
Handle finisher plate and glass lid with care so not to cause
damage.
I
It is desirable for easy installation to mark each point before
removal.
CAUTION:
Always work with a helper.
GI
MA
EM
LC
EC
FE
CL
MT
AT
AX
SU
BR
ST
RS
HA
SC
EL
IDX
SUNROOF
Removal and Installation
BT-45
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст