Infiniti G20 (P11). Manual — part 130
![](/vehicles/zatt/wheiso/zix/ksche.png)
SBT851
GI
MA
EM
LC
EC
FE
CL
MT
AT
AX
SU
BR
ST
RS
HA
SC
EL
IDX
BODY FRONT END
Removal and Installation (Cont’d)
BT-15
![](/vehicles/zatt/wheiso/zix/xcalk.png)
Removal and Installation
NCBT0005
I
When removing or installing trunk lid, place a cloth or other padding on the rear fender panels. This pre-
vents vehicle body from being scratched.
I
Bumper fascia is made of plastic. Do not use excessive force and be sure to keep oil away from it.
I
Trunk lid adjustment: Adjust at hinge-trunk lid portion for proper trunk lid fit.
I
Trunk lid lock system adjustment: Adjust striker so that it is in the center of the lock. After adjustment, check
trunk lid lock operation.
I
After installation, make sure that trunk lid and fuel filler lid open smoothly.
WARNING:
I
Be careful not to scratch trunk lid stay when installing trunk lid. A scratched stay may cause gas
leakage.
I
The contents of the trunk lid stay are under pressure. Do not take apart, puncture, apply heat or
allow fire near it.
REAR BUMPER ASSEMBLY
NCBT0005S01
1. Remove clips left and right chipping protectors.
2. Remove bolts securing left and right rear fenders to bumper fascia.
3. Remove clips securing bumper fascia.
4. Open bumper fascia side outward to disengage from side clip.
5. Extract bumper fascia assembly after removing the clamps fixing it.
6. Remove energy absorber.
7. Remove trunk floor carpet.
8. Working from inside the trunk, remove left and right plugs from floor and then remove bumper reinforce-
ment mounting bolts.
9. Extract bumper reinforcement.
BODY REAR END AND OPENER
Removal and Installation
BT-16
![](/vehicles/zatt/wheiso/zix/thosso.png)
SBT653-A
GI
MA
EM
LC
EC
FE
CL
MT
AT
AX
SU
BR
ST
RS
HA
SC
EL
IDX
BODY REAR END AND OPENER
Removal and Installation (Cont’d)
BT-17
![](/vehicles/zatt/wheiso/zix/man.png)
SBT654-A
BODY REAR END AND OPENER
Removal and Installation (Cont’d)
BT-18
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст