Infiniti QX56 (JA60). Manual — part 1037
![](/vehicles/zatt/vend/genn/dint.png)
WW-24
< COMPONENT DIAGNOSIS >
FRONT WIPER AUTO STOP SIGNAL CIRCUIT
Check continuity between IPDM E/R harness connector and front
wiper motor harness connector.
Does continuity exist?
YES
>> Replace front wiper motor. Refer to
NO
>> Repair or replace harness.
IPDM E/R
Front wiper motor
Continuity
Connector
Terminal
Connector
Terminal
E122
43
E23
6
Yes
WKIA2829E
![](/vehicles/zatt/vend/genn/ginoun.png)
FRONT WIPER MOTOR GROUND CIRCUIT
WW-25
< COMPONENT DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
FRONT WIPER MOTOR GROUND CIRCUIT
Diagnosis Procedure
INFOID:0000000005146778
Regarding Wiring Diagram information, refer to
.
1.
CHECK FRONT WIPER MOTOR (GROUND) OPEN CIRCUIT
1. Turn the ignition switch OFF.
2. Disconnect front wiper motor.
3. Check continuity between front wiper motor harness connector
and ground.
Does continuity exist?
YES
>> Front wiper motor ground circuit is normal.
NO
>> Repair or replace harness.
Front wiper motor
Ground
Continuity
Connector
Terminal
E23
1
Yes
WKIA2828E
![](/vehicles/zatt/vend/genn/drinde.png)
WW-26
< COMPONENT DIAGNOSIS >
WASHER SWITCH
WASHER SWITCH
Description
INFOID:0000000005146779
• Washer switch is integrated with combination switch.
• Combination switch switches polarity between front washer operating and rear washer operating to supply
power to the front and rear washer motor on ground.
Component Inspection
INFOID:0000000005146780
1.
CHECK FRONT WASHER SWITCH
1. Turn the ignition switch OFF.
2. Disconnect combination switch.
3. Check continuity between the combination switch terminals.
Does continuity exist?
YES
>> GO TO 2.
NO
>> Replace combination switch. Refer to
WW-85, "Wiper and Washer Switch"
2.
CHECK REAR WASHER SWITCH
ALLIA0350GB
A: Terminal 14
B: Terminal 12
C: Terminal 13
D: Terminal 11
ALLIA0839ZZ
JPLIA0164GB
Combination switch
Condition
Continuity
Terminal
11
12
Front washer switch ON
Yes
13
14
![](/vehicles/zatt/vend/genn/jve.png)
WASHER SWITCH
WW-27
< COMPONENT DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
1. Turn the ignition switch OFF.
2. Disconnect combination switch.
3. Check continuity between the combination switch terminals.
Does continuity exist?
YES
>> Wiper and washer switch is normal.
NO
>> Replace combination switch. Refer to
WW-85, "Wiper and Washer Switch"
A: Terminal 14
B: Terminal 12
C: Terminal 13
D: Terminal 11
ALLIA0840ZZ
JPLIA0164GB
Combination switch
Condition
Continuity
Terminal
11
14
Rear washer switch ON
Yes
12
13
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст