Infiniti QX56 (JA60). Manual — part 1052
WW-84
< ON-VEHICLE REPAIR >
FRONT WASHER PUMP
FRONT WASHER PUMP
Washer Motor
INFOID:0000000005146806
REMOVAL AND INSTALLATION
Removal
1. Remove washer fluid reservoir. Refer to
WW-83, "Washer Fluid Reservoir"
.
2. Remove washer motor (1) in the direction of the arrow as
shown, and remove from washer fluid reservoir (2).
Installation
Installation is in the reverse order of removal.
CAUTION:
When installing front and rear washer motor, there should be no packing twists, etc.
WKIA4564E
FRONT WIPER AND WASHER SWITCH
WW-85
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
FRONT WIPER AND WASHER SWITCH
Wiper and Washer Switch
INFOID:0000000005146807
REMOVAL AND INSTALLATION
Removal
1. Remove steering column covers.
2. Remove wiper washer switch connector.
3. Pinch tabs at wiper and washer switch base and slide switch
away from steering column to remove.
Installation
Installation is in the reverse order of removal.
WKIA0071E
WW-86
< ON-VEHICLE REPAIR >
REAR WIPER AND WASHER SYSTEM
REAR WIPER AND WASHER SYSTEM
Rear Wiper Arm
INFOID:0000000005146808
REMOVAL AND INSTALLATION
Removal
1. Remove wiper arm cover, and remove rear wiper arm nut.
2. Remove the wiper arm.
3. Remove wiper blade.
Installation
1. Operate rear wiper motor one full cycle, then turn "off " (Auto Stop).
2. Clean up the pivot area as illustrated. This will reduce the possi-
bility of wiper arm looseness.
3. Install wiper blade.
4. Install rear wiper arm so that the arm rests in the stopper and
tighten rear wiper arm nut.
5. Install wiper arm cover.
Rear Wiper Motor
INFOID:0000000005146809
REMOVAL AND INSTALLATION
LKIA0608E
SEL024J
REAR WIPER AND WASHER SYSTEM
WW-87
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
Removal
1. Remove wiper arm. Refer to
.
2. Remove pivot cap.
3. Remove back door lock assembly. Refer to
.
4. Disconnect rear wiper motor connector.
5. Remove rear wiper motor bolts, and remove rear wiper motor.
Installation
CAUTION:
Do not drop the wiper motor or cause it to contact other parts.
1. Install rear wiper motor to the vehicle.
2. Connect rear wiper motor connector.
3. Install back door lock assembly. Refer to
4. Install pivot cap.
5. Install wiper arm. Refer to
.
Rear Washer Nozzle Adjustment
INFOID:0000000005146810
• This vehicle is equipped with a non-adjustable rear washer nozzle.
• If not satisfied with washer fluid spray coverage, confirm that the washer nozzle is installed correctly.
• If the washer nozzle is installed correctly, and the washer fluid spray coverage is not satisfactory, replace the
washer nozzle.
WKIA4567E
1.
Wiper arm cover
2.
Wiper arm and blade
3.
Pivot cap
4.
Rear wiper motor
5.
Wiper arm stop
6.
Rear wiper arm nut
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст