Infiniti F50. Manual — part 519
![](/vehicles/zatt/pasieses/thed/wonald.png)
REAR BUMPER
EI-17
C
D
E
F
G
H
J
K
L
M
A
B
EI
REAR BUMPER
PFP:H5022
Removal and Installation
EIS0013I
CAUTION:
●
Bumper fascia is made of resin; do not apply pressure to or let oils contact its surface.
PIIA0035E
![](/vehicles/zatt/pasieses/thed/shonling.png)
EI-18
REAR BUMPER
REMOVAL
1.
Remove trunk trim. Refer to
EI-52, "Removal and Installation"
2.
Remove rear combination lamp assembly. Refer to
LT-80, "REAR COMBINATION LAMP"
3.
Remove bumper fascia screws from both right/left rear fender. (Refer to B and C shown in figure)
4.
Remove both right/left fender protector clips and screws, and remove fender protector. (Refer to A and B
shown in figure)
5.
Remove bumper fascia clips. (Refer to D shown in figure)
6.
Remove bumper fascia bolts and nuts. (Refer to E and F shown in figure)
7.
Pull out center of bumper fascia, and remove bumper fascia from clips. (Refer to G shown in figure)
8.
Remove bumper fascia assembly.
9.
Remove bumper reinforcement assembly nuts. (Refer to H shown in figure)
CAUTION:
To remove rear bumper molding, remove rear bumper center molding first, then rear bumper side
molding, respectively.
INSTALLATION
Install in the reverse order of removal.
Removal of Bumper Side Brackets
Shave head of rivet with drill (4.0 to 4.5 mm dia).
Installation of Bumper Side Brackets
Install bracket to fascia firmly with hand riveter.
PIIA0216E
![](/vehicles/zatt/pasieses/thed/venadetkenee.png)
FRONT GRILLE
EI-19
C
D
E
F
G
H
J
K
L
M
A
B
EI
FRONT GRILLE
PFP:62310
Removal and Installation
EIS0013J
REMOVAL
1.
Apply protection tapes around outer circumference of front grille (bumper fascia side).
2.
Remove clips on upper side of grille.
3.
Push down tips of four turn fasteners from rear side of grille. Pull out grille. Disconnect turn fasteners and
remove grille.
INSTALLATION
Install in the reverse order of removal.
PIIA0036E
![](/vehicles/zatt/pasieses/thed/ffoheash.png)
EI-20
COWL TOP
COWL TOP
PFP:66100
Removal and Installation
EIS0013K
REMOVAL
1.
Remove both right/left wiper arms from vehicle. Refer to
WW-19, "Removal and Installation for Front
Wiper Arms, Adjustment for Front Wiper Arms Stop Location"
.
2.
Remove brake fluid check cover and ABS unit cover. Refer to
EM-11, "Removal and Installation"
.
3.
Remove clips of both cowl top seal rubber and cowl top cover, then remove cowl top cover.
INSTALLATION
Install in the reverse order of removal.
PIIA0037E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст