Infiniti I35 (A33). Manual — part 401
![](/vehicles/zatt/ltherawowha/yose/wnzcam.png)
Wiring Diagram — W/ANT —
NHEL0085
MEL659R
GI
MA
EM
LC
EC
FE
AT
AX
SU
BR
ST
RS
BT
HA
SC
IDX
AUDIO ANTENNA
Wiring Diagram — W/ANT —
EL-205
![](/vehicles/zatt/ltherawowha/yose/sata.png)
Location of Antenna
NHEL0087
MEL378K
SEL250I
Window Antenna Repair
NHEL0250
ELEMENT CHECK
NHEL0250S01
1.
Attach probe circuit tester (in ohm range) to antenna terminal
on each side.
If an element is OK, continuity should exist.
If an element is broken, no continuity should exist. Go to step
2.
AUDIO ANTENNA
Location of Antenna
EL-206
![](/vehicles/zatt/ltherawowha/yose/rur.png)
SEL122R
SEL252I
I
When measuring continuity, wrap tin foil around the top of
probe. Then press the foil against the wire with your fin-
ger.
SEL253I
2.
To locate broken point, move probe along element. Tester
needle will swing abruptly when probe passes the point.
ELEMENT REPAIR
Refer to “Filament Repair”, “REAR WINDOW DEFOGGER” (EL-
192).
GI
MA
EM
LC
EC
FE
AT
AX
SU
BR
ST
RS
BT
HA
SC
IDX
AUDIO ANTENNA
Window Antenna Repair (Cont’d)
EL-207
System Description
NHEL0222
OUTLINE
NHEL0222S01
Electric sunroof system consists of
I
Sunroof switch
I
Sunroof motor
I
Smart entrance control unit
Smart entrance control unit controls retained power operation.
OPERATION
NHEL0222S03
The sunroof can be opened or closed and tilted up or down with the sunroof switch.
RETAINED POWER OPERATION
NHEL0222S02
When the ignition switch is turned to OFF position from ON or START position, power is supplied for 45 sec-
onds
I
to sunroof motor terminal 6
I
from smart entrance control unit terminal 46.
When power is supplied, the electrical sunroof can be operated.
The retained power operation is canceled when the driver or passenger side door is opened.
RAP signal period can be changed by CONSULT-II (EL-211).
INTERRUPTION DETECTION FUNCTION
NHEL0222S04
The CPU of sunroof motor monitors the sunroof motor operation and the sunroof position (full closed or other)
for sunroof by the signals from encoder and limit switch in sunroof motor.
When sunroof motor detects interruption during the following close operation,
I
automatic close operation when ignition switch is in the “ON” position
I
automatic close operation during retained power operation
sunroof switch controls the motor for open and the sunroof will operate about 150 mm (5.91 in).
POWER SUNROOF
System Description
EL-208
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст