Infiniti G37 Coupe. Manual — part 1358
![](/vehicles/zatt/keash/veak/tyos.png)
TRANSMISSION ASSEMBLY
TM-285
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
63. Remove manual shaft retaining pin with pair of nippers.
64. Remove manual plate (with parking rod) from manual shaft.
65. Remove parking rod from manual plate.
66. Remove manual shaft from transmission case.
67. Remove manual shaft oil seals using a flat-bladed screwdriver.
CAUTION:
Be careful not to scratch transmission case.
SCIA2329E
SCIA5715E
SCIA5220E
SCIA5716E
SCIA2331E
![](/vehicles/zatt/keash/veak/fir.png)
TM-286
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
TRANSMISSION ASSEMBLY
68. Remove detent spring and spacer from transmission case.
69. Using pair of snap ring pliers, remove snap ring from transmis-
sion case.
70. Remove servo assembly (with return spring) from transmission
case.
71. Remove return spring from servo assembly.
72. Remove O-rings from servo assembly.
SCIA5248E
SCIA2333E
SCIA5679E
SCIA5717E
SCIA5719E
![](/vehicles/zatt/keash/veak/quel.png)
TRANSMISSION ASSEMBLY
TM-287
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
73. Remove needle bearing (1) from rear extension.
74. Remove parking actuator support from rear extension.
75. Remove parking pawl (with return spring) and pawl shaft from
rear extension.
76. Remove return spring (1) from parking pawl (2).
77. Remove rear oil seal (1) from rear extension using flat-bladed
screwdrivers (A).
CAUTION:
Be careful not to scratch rear extension.
SCIA6179J
SCIA3423E
SCIA3424E
SCIA6180J
JPDIA0033ZZ
![](/vehicles/zatt/keash/veak/helowhib.png)
TM-288
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
TRANSMISSION ASSEMBLY
Assembly
INFOID:0000000001672298
1.
As shown in the figure, use a drift [22 mm (0.87 in) dia. commer-
cial service tool] to drive manual shaft oil seals into the transmis-
sion case until it is flush.
CAUTION:
• Do not reuse manual shaft oil seals.
• Apply ATF to manual shaft oil seals.
2.
Install detent spring and spacer in transmission case. Tighten
detent spring and spacer bolt to the specified torque.
3.
Install manual shaft to transmission case.
4.
Install parking rod to manual plate.
SCIA5259E
SCIA5248E
SCIA5716E
SCIA5220E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст