Infiniti M35/M45 Y50. Manual — part 87
ON-VEHICLE SERVICE
AT-271
D
E
F
G
H
I
J
K
L
M
A
B
AT
ii.
Install oil pan (3) (with oil pan gasket), clips (1) and brackets (2)
to transmission case.
: Front
: Bolt (22)
CAUTION:
●
Install it so that drain plug comes to the position as
shown in the figure.
●
Be careful not to pinch harnesses.
●
Completely remove all moisture, oil and old gasket, etc.
from oil pan mounting surface.
●
Be careful with installation direction of brackets (2).
iii.
Tighten oil pan mounting bolts to the specified torque in numeri-
cal order shown in the figure after temporarily tightening them.
Tighten oil pan mounting bolts to the specified torque. Refer to
.
CAUTION:
Do not reuse oil pan mounting bolts.
7.
Install drain plug to oil pan. Tighten a necessary drain plug with
specified torque. Refer to
.
CAUTION:
Do not reuse drain plug gasket.
8.
Install control rod. Refer to
AT-226, "Control Rod Removal and
.
9.
Install rear propeller shaft. Refer to
PR-8, "Removal and Installation"
.
10. Install exhaust front tube and center muffler. Refer to
EX-5, "Removal and Installation"
.
11. Pour ATF into A/T assembly. Refer to
.
12. Connect the battery cable to the negative terminal.
SCIA8035E
SCIA4113E
AT-272
AIR BREATHER HOSE
AIR BREATHER HOSE
PFP:31098
Removal and Installation
NCS001QX
VQ35DE ENGINE MODEL
Refer to the figure below for air breather hose removal and installation procedure.
CAUTION:
●
When installing an air breather hose, be careful not to be crushed or blocked by folding or bend-
ing the hose.
●
When inserting a hose to the transmission tube, be sure to insert it fully until its end reaches the
tube bend “R” portion.
SCIA7067E
AIR BREATHER HOSE
AT-273
D
E
F
G
H
I
J
K
L
M
A
B
AT
VK45DE ENGINE MODEL
Refer to the figure below for air breather hose removal and installation procedure.
CAUTION:
●
When installing an air breather hose, be careful not to be crushed or blocked by folding or bend-
ing the hose.
●
When inserting a hose to the transmission tube, be sure to insert it fully until its end reaches the
tube bend “R” portion.
●
When inserting a hose to the air breather tube, be sure to insert it fully until its end reaches the
tube spool portion.
SCIA6953E
AT-274
TRANSMISSION ASSEMBLY
TRANSMISSION ASSEMBLY
PFP:31020
Removal and Installation (2WD Models)
NCS001QY
COMPONENTS
VQ35DE models
SCIA6751E
1.
A/T assembly
2.
A/T fluid level gauge
3.
A/T fluid charging pipe
4.
O-ring
5.
Copper washer
6.
Fluid cooler tube
7.
Bracket
8.
Rear engine mounting member
9.
Engine mounting insulator (rear)
Refer to GI section to make sure icons (symbol marks) in the figure. Refer to
However, refer to the following symbols for others.
:
For tightening torque, refer to
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст