Infiniti M35/M45 Y50. Manual — part 94
![](/vehicles/zatt/cen/houeebante/qull.png)
OVERHAUL
AT-299
D
E
F
G
H
I
J
K
L
M
A
B
AT
VK45DE models for 2WD
SCIA7021E
![](/vehicles/zatt/cen/houeebante/ndil.png)
AT-300
OVERHAUL
AWD models
SCIA7020E
![](/vehicles/zatt/cen/houeebante/ker.png)
DISASSEMBLY
AT-301
D
E
F
G
H
I
J
K
L
M
A
B
AT
DISASSEMBLY
PFP:31020
Disassembly
NCS001R3
CAUTION:
Do not disassemble parts behind Drum Support. Refer to
AT-17, "Cross-Sectional View (VQ35DE Mod-
,
AT-18, "Cross-Sectional View (VK45DE Models for 2WD)"
1.
Drain ATF through drain plug.
2.
Remove torque converter by holding it firmly and turing while
pulling straight out.
3.
Check torque converter one-way clutch using a check tool as
shown at figure.
a.
Insert a check tool into the groove of bearing support built into
one-way clutch outer race.
b.
When fixing bearing support with a check tool, rotate one-way
clutch spline using a screwdriver.
c.
Make sure that inner race rotates clockwise only. If not, replace
torque converter assembly.
4.
Remove tightening bolts (1) for converter housing and transmis-
sion case.
: Bolt (8)
●
Self-sealing bolts (2)
5.
Remove converter housing from transmission case.
CAUTION:
Be careful not to scratch converter housing.
SCIA5010E
SCIA3171E
SCIA7985E
![](/vehicles/zatt/cen/houeebante/sear.png)
AT-302
DISASSEMBLY
6.
Remove O-ring from input clutch assembly.
7.
Remove tightening bolts for oil pump assembly and transmis-
sion case.
8.
Attach the sliding hammers to oil pump assembly and extract it
evenly from transmission case.
CAUTION:
●
Fully tighten the sliding hammer screws.
●
Make sure that bearing race is installed to the oil pump
assembly edge surface.
9.
Remove O-ring from oil pump assembly.
SCIA5011E
SCIA2300E
SCIA5474E
SCIA5172E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст