Mitsubishi Montero (1991+). Manual — part 183
THROTTLE POSITION SENSOR (TPS) RESISTANCE TABLE
Application (1) Terminal (Ground-Output) Ohms
Colt Vista
Closed . . . . . .. 2-1 . . .. 3500-6500
Open . . . . . .. (2) 2-3 . . 3500-6500
Eclipse 2.0L (VIN R&U)
Closed . . . . . .. 2-3 . . .. 3500-6500
Open . . . . . .. (2) 3-4 . . 3500-6500
Pickup & Ram-50 3.0L
Closed . . . . . .. 1-4 . . .. 3500-6500
Open . . . . . .. (2) 2-3 . . 3500-6500
Stealth & 3000GT
Closed . . . . . .. 4-1 . . .. 3500-6500
Open . . . . . .. (2) 4-2 . . 3500-6500
All Others
Closed . . . . . .. 1-4 . . .. 3500-6500
Open . . . . . .. (2) 2-4 . . 3500-6500
(1) - Measure across TPS terminals with connector disconnected.
(2) - Resistance should increase smoothly.
VEHICLE SPEED SENSOR CONTINUITY TEST TABLE ( 1)
Application (2) Continuity
All Models . . . 4 Changes Per Revolution
(1) - Measure continuity at back of speedometer.
See L - WIRING DIAGRAMS article in the
ENGINE PERFORMANCE Section.
(2) - With ECU connector disconnected. Turn speedometer
cable to cycle reed switch on and off.
VEHICLE SPEED SENSOR VOLTAGE TEST TABLE (1)
Application (2) Volts
All Models
Ignition switch OFF . . . . 1 Or Less
Ignition switch ON . . . . ... 4.5-4.9
(1) - Measure voltage at back of speedometer. See
L - WIRING DIAGRAMS article in the ENGINE
PERFORMANCE Section.
(2) - With ECU connector disconnected. Turn speedometer
cable to cycle reed switch on and off.
![](/vehicles/winoney/jueshecothe/henees/ohtes.png)
SERVICE INDICATOR & WARNING LIGHTS
1991 Mitsubishi Montero
1983-92 MAINTENANCE
Mitsubishi Service Indicator & Warning Lights
Montero
SERVICE INDICATOR & WARNING LIGHTS
Fig. 1: 1983-88 Dash Gauges & Warning Lights
Courtesy of Mitsubishi Motor Sales of America, Inc.
![](/vehicles/winoney/jueshecothe/henees/lyem.png)
Fig. 2: 1989-92 Dash Gauges & Warning Lights
Courtesy of Mitsubishi Motor Sales of America, Inc.
OIL PRESSURE WARNING LIGHT
Light comes on with the ignition switch in the "ON" position
as a bulb check, but should go out shortly after engine is started. If
light remains on or comes on while driving, it indicates low oil
pressure and possible system malfunction. Have the system checked and
serviced immediately. Do not operate vehicle until cause is located
and corrected.
ALTERNATOR WARNING LIGHT
Light comes on with the ignition switch in the "ON" position
as a bulb check and goes out after engine is started. If light remains
on or comes on while driving, it indicates possible fault in the
electrical charging system. The alternator belt may be loose or
broken. Have the system checked and serviced promptly. Do not drive
vehicle if alternator belt is loose or broken.
"BRAKE" WARNING LIGHT
Light comes on with the ignition switch in the "ON" position
as a bulb check and goes out after engine is started. Light will also
come on with the parking brake fully or partially engaged. If light
remains on or comes on at any other time, it indicates low brake fluid
level in the master cylinder reservoir or the parking brake switch may
be damaged. Have the system checked and serviced immediately if brake
fluid level is low. Do not continue driving if further trouble is
experienced.
"CHECK ENGINE" WARNING LIGHT (IF EQUIPPED)
Light is designed to come on briefly with the ignition switch
in the "ON" position as a bulb check. If light remains on or comes on
while driving, it indicates fault in an exhaust gas related component
and the system is not functioning properly. Have the system checked
and serviced as soon as possible.
"MAINTENANCE REQUIRED" WARNING LIGHT (IF EQUIPPED)
Light comes on at 50,000 miles, 80,000 miles, 100,000 miles
and 120,000 miles (150,000 miles on 1990-91 models) as a service
reminder that it is time for the periodic maintenance of the emission
control system. Have the system inspected and serviced as necessary
when light comes on. Continued operation of vehicle without having
system serviced after warning light comes on may adversely affect
proper performance of the emission control system. Reset warning
light, after the system has been checked, by pushing the reset switch
in front of the combination meter. Remove the warning light bulb after
the last maintenance service at 120,000 miles (150,000 miles on 1990-
91 models).
"A/T TEMPERATURE" WARNING LIGHT (IF EQUIPPED)
Light comes on when the automatic transmission fluid
temperature becomes abnormally high. If light comes on, reduce engine
speed, stop car and put it in "P" (Park) position. Leave engine
running until light goes out. Normal vehicle operation may be resumed
after light has gone out. If light does not go out, have the system
checked and serviced as necessary.
WHEEL LOCK INDICATOR LIGHT (IF EQUIPPED)
Light comes on when automatic free-wheeling hubs are locked.
If ignition is turned off, indicator light will not come on when
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст