Mitsubishi Eclipse / Eclipse Spyder (2000-2002). Service and repair manual — part 501
AUTOMATIC TRANSAXLE DIAGNOSIS
TSB Revision
AUTOMATIC TRANSAXLE
23A-296
STEP 3. Check the signal voltage at PCM connector C-57
<2.4L Engine> or C-59 <3.0L Engine> by backprobing.
(1) Do not disconnect connector C-57 <2.4L Engine> or C-59
<3.0L Engine>.
(2) Turn the ignition switch to "ON" position.
(3) Measure the voltage between terminal 75 and ground by
backprobing.
•
Voltage should be battery positive voltage.
(4) Turn the ignition switch to "LOCK" (OFF) position.
Q: Is the voltage normal?
YES : Go to Step 5.
NO : Go to Step 4.
STEP 4. Check connectors C-57 <2.4L Engine> or C-59
<3.0L Engine> at PCM and C-28 at inter mediate connector
for damage.
Q: Are the connectors in good condition?
YES : Replace the PCM.
NO : Repair or replace it. Refer to GROUP 00E, Harness
Connector Inspection
.
AC001657
CONNECTOR: C-57 <2.4L ENGINE> OR
C-59 <3.0L ENGINE>
AK
PCM
AC002097
C-57 <2.4L ENGINE> OR
C-59 <3.0L ENGINE>
CONNECTOR HARNESS
SIDE VIEW
AE
AC001657
CONNECTOR: C-57 <2.4L ENGINE> OR
C-59 <3.0L ENGINE>
AK
PCM
AC001741
CONNECTOR: C-28
AM
AUTOMATIC TRANSAXLE DIAGNOSIS
TSB Revision
AUTOMATIC TRANSAXLE
23A-297
STEP 5. Check the signal voltage at auto-cruise control-
ECU connector C-20 by backprobing.
(1) Do not disconnect connector C-20.
(2) Turn the ignition switch to "ON" position.
(3) Measure the voltage between terminal 3 and ground by
backprobing.
•
Voltage should be battery positive voltage.
(4) Turn the ignition switch to "LOCK" (OFF) position.
Q: Is the voltage normal?
YES : Go to Step 7.
NO : Go to Step 6.
STEP 6. Check harness for short circuit to ground, open
circuit or damage between PCM connector C-57 <2.4L
Engine> or C-59 <3.0L Engine> terminal 75 and auto-cruise
control-ECU connector C-20 terminal 3.
Q: Is the harness wire in good condition?
YES : Go to Step 7.
NO : Repair it.
AC001741
CONNECTOR: C-20
AO
AC002119
C-20 CONNECTOR
HARNESS SIDE VIEW
AE
AC001657
CONNECTOR: C-57 <2.4L ENGINE> OR
C-59 <3.0L ENGINE>
AK
PCM
AC001741
CONNECTOR: C-20
AO
AUTOMATIC TRANSAXLE DIAGNOSIS
TSB Revision
AUTOMATIC TRANSAXLE
23A-298
STEP 7. Check connector C-20 at auto-cruise control-ECU
connector for damage.
Q: Is the connector in good condition?
YES : Replace the auto-cruise control-ECU.
NO : Repair or replace it. Refer to GROUP 00E, Harness
Connector Inspection
.
AC001741
CONNECTOR: C-20
AO
AUTOMATIC TRANSAXLE DIAGNOSIS
TSB Revision
AUTOMATIC TRANSAXLE
23A-299
INSPECTION PROCEDURE 17: Shift Switch Assembly System <Vehicles with Sport Mode>
AC004697
Shift Switch Assembly System Circuit
AC
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст