Mitsubishi Colt Ralliart. Manual — part 493
![](/vehicles/winoney/ama/flend/yolug.png)
RADIO AND CD PLAYER
CHASSIS ELECTRICAL
54A-117
3. Turn the ignition key to the "ACC" or "ON"
position.
P901
AC211324 AB
CD button
Power button
Memory select
button (1, 6)
4. Press the "PWR" button, and "CODE" will be
displayed.
ACX01948
5. Press number 1 through number 4 memory select
button to set the four-digit security code shown on
the card. Every time each digit key is pressed, the
figure changes as follows: 0 to 1 to 2 to 3 to 4 to 5
to 6 to 7 to 8 to 9 to 0
6. Press the "CD" button, and a beep will be heard. If
entered correctly, the radio and CD player will
work.
7. If the security code is not accepted, "1Err" is
displayed. In a few seconds, it will change to
"CODE." Then repeat steps 5 and 6.
NOTE:
.
•
The anti-theft system will allow three attempts
maximum to input the correct code.
•
The second error is displayed as "2 Err."
When the third error is made, "3 Err" is dis-
played and then the display changes to "OFF."
If this should occur, the unit will not work any
more.
•
To input the security code again, turn the igni-
tion switch to the "ACC" or "ON" position and
wait for one hour when "OFF" is displayed.
After "OFF" disappears on the display and
changes into "CODE" the security code can be
input again.
THREE-MINUTE OPERATION MODE
P901
AC211324 AC
Eject button
Power button
To facilitate replacement or check, the radio and CD
player can be operated for three minutes without
inputting the security code.
1. Press the "PWR" button and "EJECT" button
together to operate the radio and CD player.
2. In three minutes the unit will not be able to work.
Then the radio and CD player will be switched off.
SPEAKER TEST
M1544005400396
Enter the speaker test mode according to the follow-
ing steps:
1. Turn the Ignition switch to the "ACC" or "ON"
position and switch off the radio and CD player.
AC401635
Memory select button (1, 6)
TUNE/SEEK button
Radio and CD player
AB
2. Press the following buttons in that order within
sixty seconds from step (1).
(1) Memory select "1" button
(2) "TUNE/SEEK (DOWN)" button
(3) "TUNE/SEEK (UP)" button
(4) Memory select "6" button
Main
Index
Group
TOC
![](/vehicles/winoney/ama/flend/gorito.png)
ACX01941
Front speaker and
tweeter (LH)
Rear speaker (LH)
Illuminates
Front speaker and
tweeter (RH)
Rear speaker (RH)
Off
Flash
AF
RADIO AND CD PLAYER
CHASSIS ELECTRICAL
54A-118
3. Check that the speaker, which is displayed on the
radio panel display, sounds (If the memory select
"6" button is pressed, the speaker will be
changed).
4. If a button other than the memory select "6" button
and "EJECT" button (CD) is pressed, or the
ignition switch is turned to "LOCK" (OFF) position,
you will exit from the speaker test mode.
Main
Index
Group
TOC
![](/vehicles/winoney/ama/flend/bele.png)
RADIO AND CD PLAYER
CHASSIS ELECTRICAL
54A-119
RADIO AND CD PLAYER
REMOVAL AND INSTALLATION
M1544011500024
AC401634 AB
1
2
2
3
4
5
6
6
7
1.5 ± 0.5 N·m
1.5 ± 0.5 N·m
Removal steps
1.
Upper centre panel (Refer to
GROUP 52A, Instrument Panel
Assembly
2.
Console panel (Refer to GROUP
52A, Instrument Panel Assembly
3.
Lower contre panel (Refer to
GROUP 52A, Instrument Panel
Assembly
4.
Heater control panel (Refer to
GROUP 52A, Instrument Panel
Assembly
5.
Radio and CD player assembly
6.
Bracket
7.
Radio and CD player
Removal steps (Continued)
Main
Index
Group
TOC
![](/vehicles/winoney/ama/flend/bof.png)
SPEAKER
CHASSIS ELECTRICAL
54A-120
SPEAKER
REMOVAL AND INSTALLATION
M1544002600669
AC314155
1
2
AB
3
4
5
6
Front speaker removal steps
1.
Pull handle box
2.
Front door trim (Refer to GROUP
52A, Door trim
.)
3.
Front speaker
Rear speaker removal steps
4.
Power window switch assembly
5.
Rear door trim (Refer to GROUP
52A, Door trim
6.
Rear speaker
Main
Index
Group
TOC
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст