Acura RL (1996-2004 year). Manual — part 720
'99-01 Models
'99 - 01 Models
8. Remove the steering wheel using a commercially
available steering wheel puller.
'96 - 98 Models
'99 - 01 Model
9. Remove the steering column covers.
'96 - 98 Models
Main Menu
Table of Contents
11. Remove the cable reel from the column.
13. Carefully install the cable reel on the steering col-
umn shaft. Then connect the 4P connector to the
cable reel, and connect the 2P connector to the SRS
main harness, then attach the cable reel 2P connec-
tor to the connector holder.
'96-98 Models
'99 - 01 Models
CAUTION:
• Before installing the steering wheel, the front
wheels should be aligned straight ahead.
• Be sure to install the harness wires so that they
are not pinched or interfering with other vehicle
parts.
• After reassembly, confirm that the wheels are
still turned straight ahead and that the steering
wheel spoke angle is correct (road test). If minor
spoke angle adjustment is necessary, do so only
by adjusting the tie-rods, not by removing and
repositioning the steering wheel.
12. Set the cancel sleeve so that the projections are
aligned vertically.
Replacement (cont'd)
10. Disconnect the 4P connector between the cable reel
and combination switch harness, and remove the
2P connector between the cable reel and SRS main
harness.
'96 - 98 Models
Cable Reel
Main Menu
Table of Contents
'99 - 01 Models
'99 - 01 Models
16. Install the steering wheel, then connect the radio
remote switch connector, horn connector and cruise
control set/resume/cancel switch connector.
'96 - 98 Models
14. Install the steering column covers.
15. If necessary, center the cable reel. (New replace-
ment cable reels come centered.) Do this by first
rotating the cable reel clockwise until it stops. Then
rotate it counterclockwise (about 2
1
/2 turns) until the
arrow mark on the cable reel label points straight
up.
'96 - 98 Models
'99 - 01 Models
Main Menu
Table of Contents
Replacement (cont'd)
17. Install the steering wheel nut, then install the driv-
er's airbag.
'96 - 98 Models
Cable Reel
18. Install the dashboard lower cover, and reinstall the
access panel on the steering wheel.
19. Reconnect the battery positive cable, then the nega-
tive cable.
20. After installing the cable reel, confirm proper sys-
tem operation:
• Turn the ignition switch ON (II); the SRS indica-
tor light should come on for about 6 seconds and
then go off.
• Make sure horn button works.
• Make sure the headlight and wiper switches
work.
• Go for a test drive, and make sure the cruise con-
trol switches work.
21. Enter the anti-theft code for the radio, then enter the
customer's radio station presets.
'99 - 01 Models
Main Menu
Table of Contents
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст