Acura RL (1996-2004 year). Manual — part 295
Navigation System
Symptom Troubleshooting (cont'd)
Picture is missing a red/green/blue color or
tone, or rolling picture
Diagnostic Test: Monitor Check
NOTE:
• Always check the connectors for poor connections or
loose terminals.
• Before troubleshooting, get the navigation system
anti-theft codes.
• After troubleshooting, enter the navigation system
anti-theft codes.
1 . Go into Diagnostic mode and use "RGB Color"
diagnostic under Monitor Check (see page
).
Are the red, green, and blue colored circles
shown?
YES—The system is OK.
NO—Go to step 2.
2. Turn the ignition switch to OFF.
3. Disconnect the navigation unit connector A (20P)
and display unit connector B (20P).
4. Check for loose terminals at navigation unit con-
nector A (20P) and display unit connector B (20P).
Are there loose terminals?
YES—Repair the terminal.
NO—Go to step 5.
5. Check for continuity between the appropriate termi-
nals of navigation unit connector A (20P) to display
unit connector B (20P) based on the missing color(s).
Missing
color
Blue
Green
Red
Navigation
unit
connector A
(20P)
A 1 1
A2
A1
Display unit
connector B
(20P)
B18
B9
B8
Wire
color
YEL
RED
WHT
NAVIGATION UNIT CONNECTOR A (20P)
DISPLAY UNIT CONNECTOR B (20P)
Wire side of female terminals
Is there continuity?
YES—Go to step 6.
NO—There is an open in the circuit between the dis-
play unit and the navigation unit. Check for poor con-
nections or loose terminals at the display and naviga-
tion units. If a poor connection or loose terminal is
found, replace the affected shielded harness.
Main Menu
Table of Contents
6. Check for continuity between the appropriate termi-
nals of navigation unit connector A (20P) and display
unit connector B (20P) based on the missing color(s).
Missing Navigation
color unit connector
A (20P)
Blue A 1 1
Green A2
Red A1
Display unit
connector B
(20P)
B10, B20
B10, B20
B10, B20
NAVIGATION UNIT CONNECTOR A (20P)
Wire side of female terminals
DISPLAY UNIT CONNECTOR B I20PI
Wire side of female terminals
Is there continuity?
YES—There is a short to body ground in the circuit
between the display unit and the navigation unit.
Replace the affected shielded harness.
NO—Replace the navigation unit. If the problem is
still unresolved, replace the display unit.
Main Menu
Table of Contents
Picture has lines/other issues
Diagnostic Check: Monitor Check
NOTE:
• Always check the connectors for poor connections or
loose terminals.
• Before troubleshooting, get the navigation system
anti-theft codes.
• After troubleshooting, enter the navigation system
anti-theft codes.
1 . Check for electronic aftermarket accessories (passive-
ly hidden) mounted near the display unit or the navi-
gation unit.
Are there any electronic accessories?
YES—Disable the accessories, and recheck.
NO—Go to step 2.
2. Start up the navigation picture.
Is the picture scrolling horizontally (left to right or
right to left)?
YES—Check for an open or short to ground in the C
SIG wire from navigation unit connector A (20P) ter-
minal No. 1 2 to display unit connector B (20P) termi-
nal No. 18. Also check for a short to ground between
display unit connector B terminal No. 19 and terminal
No. 20.
NO—Go to step 3.
3. Go into the Diagnostic mode and use "RGB Color"
diagnostic under Monitor Check (see page
).
Is the picture missing a red, green or blue color?
YES—Do the troubleshooting for the picture is miss-
ing a red, green or blue color or tone (see page
.
NO—Go to step 4.
(cont'd)
Main Menu
Table of Contents
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст