Defender. Manual — part 64
Engine System - General Information - Camshaft End Play
General Procedures
1. NOTE: Make sure that the camshaft is to specification.
Using the special tool, measure the end play.
Slide the camshaft in both directions. Read and note the
maximum and minimum values on the dial indicator
gauge.
1. End play = maximum value minus minimum value.
If the measurement is out of specification, install new
components.
Engine System - General Information - Camshaft Lobe Lift
General Procedures
1. Measure the diameter (1) and diameter (2) with a vernier
caliper. The difference in measurements is the lobe lift.
Engine System - General Information - Camshaft Surface Inspection
General Procedures
1. Inspect camshaft lobes for pitting or damage in the active
area. Minor pitting is acceptable outside the active area.
Engine System - General Information - Connecting Rod Cleaning
General Procedures
1.
CAUTION: Do not use a caustic cleaning solution or
damage to connecting rods may occur.
Mark and separate the parts and clean with solvent. Clean the
oil passages.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст