Defender. Manual — part 236
Exterior Lighting - Side Marker Lamp
Removal and Installation
Removal
• NOTE: This procedure covers removal and installation of the side repeater lamp.
1. Push lens firmly to the right.
2. Lift left edge and withdraw lamp unit from wing.
3. Twist bulb holder and release from lens.
4. Pull bulb from holder.
Installation
1. Fit new bulb, if necessary.
2. Fit bulb holder to lens.
3. Locate lamp unit in wing and push firmly to the left to
secure.
Exterior Lighting - Side Turn Signal Lamp
Removal and Installation
Removal
1. Remove 2 screws securing side turn signal lamp to front
fender.
2. Disconnect multiplug and remove lamp.
Installation
1. Position side turn signal lamp and connect multiplug.
2. Fit and tighten lamp securing screws.
Exterior Lighting - Stoplamp Switch
Removal and Installation
Removal
1. Remove the stoplamp switch cover.
2. Disconnect the electrical connectors.
3. Remove the stoplamp switches.
Installation
1.
CAUTION: Make sure that the brake pedal is kept in the
rest position and is not pressed or moved during the instillation
of the stoplamp switch. Failure to follow this instruction may
result in damage to the vehicle.
To install, reverse the removal procedure.
Interior Lighting - Interior Lighting
Description and Operation
COMPONENT LOCATION
• NOTE: left-hand drive (LHD) vehicle shown, right-hand drive (RHD) similar.
Item
Part Number
Description
1
-
right-hand (RH) rear door switch (if fitted)
2
-
Front interior lamp
3
-
Rear interior lamp (Not 90 model)
4
-
Tail door switch (Not 90 model)
5
-
left-hand (LH) rear door switch (if fitted)
6
-
Map reading lamp (SVX (60th anniversary) model only)
7
-
Drivers door switch
8
-
Anti-theft system module
9
-
central junction box (CJB)
10
-
Passenger door switch
11
-
Map reading lamps switch (SVX (60 anniversary) model only)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст