Defender. Manual — part 279
![](/vehicles/onond/qug/lecmbuttig/henghe.png)
Safety Belt System - Safety Belt System
Description and Operation
COMPONENT LOCATION
OVERVIEW
A three point safety belt is installed at each seat position. All the safety belts have Emergency Locking Retractors (ELR).
ELR retractors incorporate a liftshaft locking system with webbing sensor and car sensor activating mechanisms. The
webbing sensor activates the locking system if the webbing is subjected to a sharp pull. The car sensor activates the
locking system if the vehicle is subjected to sudden deceleration or a severe tilt angle.
FRONT SAFETY BELTS
The retractor of each front safety belt is attached to the related B pillar. The webbing runs from the retractor through an
upper mounting, attached to the B pillar, to an anchor point on the front seat.
The buckle for each front safety belt is to the vehicle body inside of the related front seat frame.
SECOND ROW SAFETY BELTS
The retractor of each outboard second row safety belt is attached to the body immediately behind the D pillar. The
webbing runs from the retractor, through an upper mounting on the D pillar, to an anchor point at the front of the
related wheel arch.
The retractor for the center second row safety belt is installed in the top of the seat back. The webbing runs from the
retractor, over the top of the seat, to an anchor point at the base of the seat frame.
The buckles for the second row safety belts are attached to the related seat frame.
THIRD ROW SAFETY BELTS (110 only)
The retractor of each third row safety belt is attached to the E pillar. The webbing runs from the retractor, through a
mounting on the E pillar to an anchor point on the floor. The buckles for the third row safety belts are attached to the
related seat frame.
BELTMINDER (GULF MARKETS ONLY)
The belt minder function provides warnings to the driver if the appropriate front safety belts are not fastened when
driving. The belt minder function is controlled by the instrument cluster
For additional information, refer to:
Instrument Cluster
(413-01 Instrument Cluster, Description and Operation).
.
![](/vehicles/onond/qug/lecmbuttig/realitug.png)
Safety Belt System - Front Safety Belt Buckle
Removal and Installation
Removal
1. Remove the front safety belt buckle.
Remove the M8 bolt.
Remove and discard the M10 bolt.
Installation
1. Install the front safety belt buckle.
Tighten the new M10 bolt to 23 Nm (17 lb.ft).
Tighten the M8 bolt to 23 Nm (17 lb.ft).
![](/vehicles/onond/qug/lecmbuttig/posem.png)
Safety Belt System - Front Safety Belt Retractor
Removal and Installation
Removal
1. Release the front safety belt lower anchor.
Remove the 3 bolts.
Remove the clip.
2. Release the front safety belt upper anchor.
Remove the bolt cover.
Remove the bolt.
3. Remove the front safety belt retractor trim.
Remove the 4 scrivets.
4. Remove the front safety belt retractor.
Remove the bolt.
Installation
1. Install the front safety belt retractor.
Tighten the bolt to 31 Nm (23 lb.ft).
2. Install the front safety belt retractor trim.
Install the scrivets.
3. Secure the front safety belt upper anchor.
Tighten the bolt to 31 Nm (23 lb.ft).
Install the bolt cover.
4. Secure the front safety belt lower anchor.
Tighten the bolts to 10 Nm (7 lb.ft).
Install the clip.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст