Defender. Manual — part 232
Exterior Lighting - Headlamp Adjustment
General Procedures
1. NOTE: Check main beam alignment using beam setting
equipment. Should this not be available the beam can be
temporarily checked and adjusted as follows.
Position vehicle, unladen, on level ground with tyres correctly
inflated, approximately 4 metres from a wall or screen,
marked as illustrated below.
2. The beam centres 'A' are measured horizontally on the
vehicle and dimension 'B' vertically from the ground.
3. Switch on main beam and adjust setting, as necessary,
with trimmer screws.
Exterior Lighting - Headlamp Assembly
Removal and Installation
Removal
1. Remove 4 screws and release side and turn signal lamps
from fender.
2. Disconnect multiplugs and remove side and turn signal
lamps.
3. Remove 2 screws and remove headlamp finisher.
4. Remove 4 screws securing headlamp to fender, disconnect
multiplugs and remove headlamp.
5. Remove headlamp seal.
Installation
1. Fit headlamp seal.
2. Position headlamp, connect multiplugs, fit and tighten
headlamp screws.
3. Fit headlamp finisher and secure with screws.
4. Position side and turn signal lamps, connect multiplugs and
secure with screws.
5. Reset headlamp alignment.
For additional information, refer to:
Headlamp Adjustment
(417-01 Exterior Lighting, General Procedures).
Exterior Lighting - Headlamp Leveling Motor
Removal and Installation
Removal
1. Remove headlamp assembly.
For additional information, refer to:
Headlamp Assembly
(417-01 Exterior Lighting, Removal and Installation).
2. Disconnect headlamp leveling motor harness plug.
3. Rotate headlamp leveling motor anti-clockwise to release
retaining lugs from mounting bracket on headlamp body.
4. Release headlamp leveling motor spindle from retaining
slot on headlamp bezel and withdraw headlamp leveling
motor from mounting bracket.
Installation
1. Instal headlamp leveling motor into mounting bracket and
locate motor spindle into slot in headlamp bezel.
2. Press in headlamp leveling motor and rotate clockwise to
engage retaining lugs behind mounting bracket.
3. Connect headlamp leveling motor harness plug.
4. Fit headlamp assembly.
For additional information, refer to:
Headlamp Assembly
(417-01 Exterior Lighting, Removal and Installation).
Exterior Lighting - Headlamp Leveling Switch
Removal and Installation
Removal
1. Disconnect the battery ground cable.
For additional information, refer to:
Battery Disconnect and
Connect
(414-01 Battery, Mounting and Cables, General
Procedures).
2. Remove the audio unit.
For additional information, refer to:
Audio Unit
(415-01A
Audio Unit, Removal and Installation).
3. Release the instrument panel console.
4. Disconnect the electrical connector.
5. Remove the headlamp leveling selector knob.
6. Remove the headlamp leveling switch.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст