Defender. Manual — part 249
Interior Trim and Ornamentation - Rear Door Trim Panel
Removal and Installation
Removal
1. Remove screw securing door handle escutcheon.
2. Remove escutcheon.
3. Remove interior lock button bezel.
4. Remove retaining clip and remove door glass regulator
handle.
5. Release covers and remove 2 screws securing door pull to
door.
6. Carefully release 12 clips securing trim casing to door and
remove door casing.
Installation
1. Instal trim casing to door and secure with clips.
2. Instal door glass regulator handle.
3. Instal escutcheon to door handle and tighten screw.
4. Instal door lock button bezel.
5. Instal door pull and secure with screws.
Interior Trim and Ornamentation - Rear Quarter Trim Panel
Removal and Installation
Removal
1. Pull edge of rear quarter trim panel firmly to release 2 spring
retaining clips from vertical rail at door aperture.
2. Remove rear quarter trim panel.
3. Remove spring clips from the 2 brackets on side of trim
panel.
Installation
1. Instal new spring clips to the 2 brackets on side of trim
panel.
2. Position outboard edge of trim panel in corner to abut
quarter trim panel and locate spring clips on vertical rail.
3. Press edge of trim panel firmly to secure in position.
Interior Trim and Ornamentation - Steering Column Shrouds
Removal and Installation
Removal
1. Remove the steering wheel center pad.
2. Remove the instrument cluster lower finisher.
Remove the 2 screws.
3. Release the 3 grommets from the steering column shrouds.
4. Remove the grommet.
5. Remove the 6 screws.
6. Remove the upper steering column shroud.
7. Remove the lower steering column shroud.
Installation
1. To install, reverse the removal procedure.
Tighten to 2 Nm (1 lb.ft).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст