Defender. Manual — part 193

5. Install the catalytic converter heat shield.

Tighten to 10 Nm (7 lb.ft).

6. Install the turbocharger heat shield.

Tighten to 10 Nm (7 lb.ft).

7. Tighten to 30 Nm (22 lb.ft).

8. Tighten to 30 Nm (22 lb.ft).

9. Tighten to 30 Nm (22 lb.ft).

9. Tighten to 30 Nm (22 lb.ft).

10. Install the front driveshaft.

For additional information, refer to:

Front Driveshaft

(205-01

Driveshaft, Removal and Installation).

11. NOTE: Left-hand side shown, right-hand side similar.

Install the chassis cross member.

Tighten to 85 Nm (63 lb.ft).

Exhaust System - 2.4L Duratorq-TDCi HPCR (103kW/140PS) - Puma - Front

Muffler

Removal and Installation

Removal

1.

WARNING: Do not work on or under a vehicle

supported only by a jack. Always support the vehicle on safety

stands.

Raise and support the vehicle.

2. Release the front muffler from the catalytic converter.

Remove and discard the 2 nuts.

3. Release the front muffler from the tail pipe.

Remove and discard the 3 nuts.

Remove and discard the gasket.

4. Remove the intermediate pipe and muffler.

Installation

1. NOTE: Install a new gasket.

1. NOTE: Install a new gasket.

• NOTE: Install new nuts.

To install, reverse the removal procedure.

Tighten to 30 Nm (22 lb.ft).

2. NOTE: Install new nuts.

Tighten to 30 Nm (22 lb.ft).