Frelander 2. Manual — part 522

5. NOTE: Do not disassemble further if the component
is removed for access only.

5.

Installation

Install the tire pressure antenna.

1.

Install the fender splash shield and tighten the Torx screw to 6 Nm
(4 lb.ft).

2.

Install the fender splash shield extension panel.

3.

Install the front wheel.

Refer to:

Wheel and Tire

(204-04 W heels and Tires, Removal and

Installation).

4.

Front End Body Panels - Engine Undershield

Removal and Installation

Removal

• NOTE: Removal steps in this procedure may contain installation details.

1.

WARNING: Do not work on or under a vehicle supported only

by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.

1.

Torque: 60 Nm

2.

Installation

To install, reverse the removal procedure.

1.

Front End Body Panels - Secondary Bulkhead Center PanelI6 3.2L Petrol

Removal and Installation

Removal

• NOTE: Removal steps in this procedure may contain installation details.

1.

WARNING: Make sure to support the vehicle with axle

stands.

Raise and support the vehicle.

1.

Remove the engine cover.

Refer to:

Engine Cover - I6 3.2L Petrol

(501-05 Interior Trim and

Ornamentation, Removal and Installation).

2.

Remove the plenum chamber.

Refer to:

Plenum Chamber

(412-01 Climate Control, Removal and

Installation).

3.

Release the secondary bulkhead center panel pad.

4.

Torque: 10 Nm

5.

6.

Installation

To install, reverse the removal procedure.

1.