Frelander 2. Manual — part 675
![](/vehicles/onond/oloi/toor/esawirqupu.png)
Disconnect the RH catalyst monitor sensor electrical connector.
6.
Release the catalyst monitor sensor wiring harness.
7.
8.
CAUTION: Make sure that the ball joint ball does not rotate.
Disconnect both front stabilizer bar links from the lower suspension arm.
8.
![](/vehicles/onond/oloi/toor/gupay.png)
Using the special tool, release the LH and RH tie-rod end ball joints.
Special Tool(s):
211-316
9.
10.
CAUTION: Be prepared to collect escaping fluids.
• NOTE: Make sure that all openings are sealed.
Disconnect the pressure lines from the power steering gear.
10.
Release the PAS lines.
11.
12.
WARNING: Make sure that a new steering column flexible
coupling bolt is installed.
Disconnect the lower steering column from the steering gear.
12.
![](/vehicles/onond/oloi/toor/houg.png)
Release the downpipe catalytic converters.
13.
Release the LH and RH lower suspension arms.
14.
Release the purge line from the subframe.
15.
Release the fuel line.
16.
![](/vehicles/onond/oloi/toor/hathth.png)
Support the subframe.
General Equipment:
Powertrain Jack
17.
18.
CAUTION: Make sure that new subframe bolts are installed.
Remove the front subframe cross-brace.
18.
19. CAUTIONS:
Mark the components to aid installation.
Make sure that new subframe bolts are installed.
Lower the front subframe assembly.
19.
Remove the stabilizer bar.
20.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст