Frelander 2. Manual — part 172
Install both exhaust manifolds.
Refer to:
Exhaust Manifold
(303-01A Engine - I6 3.2L Petrol,
Removal and Installation).
16.
Connect the battery ground cable and install the cover.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
17.
![](/vehicles/onond/oloi/toor/jusprd.png)
Engine - I6 3.2L Petrol - Oil Pan
Removal and Installation
Removal
Remove the cover and disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
2.
WARNING: Do not work on or under a vehicle supported only
by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2.
Remove the starter motor.
Refer to:
Starter Motor
(303-06A Starting System - I6 3.2L Petrol,
Removal and Installation).
3.
4.
WARNING: Be prepared to collect escaping oil.
CAUTION: Discard the seal.
Remove the lubricant drain plug.
4.
Disconnect the oil level sensor electrical connector.
5.
![](/vehicles/onond/oloi/toor/hedyo.png)
Release the coolant rail.
6.
Remove the dipstick tube.
7.
Remove the intake manifold lower bolts.
8.
Remove the 2 sump to gearbox bolts.
9.
![](/vehicles/onond/oloi/toor/kisongovesow.png)
Remove the 3 oil pan bolts.
10.
Remove the 31 oil pan bolts
11.
Remove the oil pan gasket.
12.
13. NOTE: Do not disassemble further if the component
is removed for access only.
Remove the oil level sensor.
13.
Installation
Install the oil level sensor.
Torque: 8 Nm
1.
For sealant information, refer to the engine specification section.
Refer to:
Specifications
(303-01A Engine - I6 3.2L Petrol,
Specifications).
2.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст