Frelander 2. Manual — part 525
![](/vehicles/onond/oloi/toor/daus.png)
Body Closures - Liftgate Alignment
General Procedures
W ith the liftgate closed, check the alignment of the
liftgate to the roof panel and bodyside panel. The
liftgate should be central in its aperture.
Refer to:
Body and Frame
(501-26 Body Repairs -
Vehicle Specific Information and Tolerance Checks,
Description and Operation).
1.
Remove the D-pillar trim panels.
Refer to:
D-Pillar Trim Panel
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
2.
Release the rear of the headliner.
3.
![](/vehicles/onond/oloi/toor/quwimy.png)
Loosen, but do not remove the liftgate hinge bolts.
4.
Position the liftgate central to the aperture.
5.
Tighten the liftgate hinge bolts.
Torque: 24 Nm
6.
Check for correct operation of the liftgate, and if necessary adjust
the liftgate striker.
Refer to:
Liftgate Striker Adjustment
(501-14 Handles, Locks,
Latches and Entry Systems, General Procedures).
7.
Attach the rear of the headliner.
8.
Install the D-pillar trim panels.
Refer to:
D-Pillar Trim Panel
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
9.
![](/vehicles/onond/oloi/toor/ffo.png)
Body Closures - Front Door
Removal and Installation
Removal
1.
CAUTION: After switching off the ignition, wait for 2 minutes
before disconnecting the battery. Failure to wait for 2 minutes will
damage the navigation computer.
Disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
Torque: 24 Nm
2.
3.
CAUTION: Protect the surrounding trim to avoid
damage.
• NOTE: This step requires the aid of another
technician.
Torque: 30 Nm
3.
![](/vehicles/onond/oloi/toor/resllauti.png)
4. NOTE: With assistance, support the door.
4.
Installation
To install, reverse the removal procedure.
1.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст