Discovery 2. Manual — part 92
ENGINE MANAGEMENT SYSTEM - V8
REPAIRS 18-2-97
Switch - cruise control (set/resume)
$% 19.75.33
Remove
1. Remove the key from the starter switch.
Disconnect both battery leads, negative lead
first. Wait ten minutes before starting work.
2. Remove driver's airbag module.
3. Release remote control switches multiplug and
leads from steering wheel base.
4. Disconnect remote control switches multiplug
from harness.
5. Remove 2 screws securing remote control
switches to steering wheel base.
6. Release and remove remote control switches
from steering wheel.
Refit
1. Fit remote control switches to steering wheel
and secure with screws.
2. Connect remote control switches multiplug to
harness.
3. Secure leads and multiplug to base of steering
wheel.
4. Fit driver's airbag module.
Switch - clutch pedal - cruise control
$% 19.75.34
Remove
1. Remove 3 fasteners and move driver's side
lower closing panel aside.
2. Disconnect multiplug from clutch pedal switch.
3. Remove switch from pedal bracket.
Refit
1. Engage switch fully into pedal bracket location
and connect multiplug.
2. Position lower closing panel and secure with
fasteners.
ENGINE MANAGEMENT SYSTEM - V8
18-2-98 REPAIRS
ECU - Cruise control
$% 19.75.49
Remove
1. Remove fixings securing fascia RH closing
panel and remove panel.
2. Remove 2 fixings and remove 'A' post lower
trim.
3. Remove 2 nuts and remove ECU from studs.
4. Disconnect multiplug from ECU and remove
ECU.
Refit
1. Position new ECU and connect multiplug.
2. Fit ECU to studs and secure with nuts.
3. Fit lower trim panel to 'A' post and secure with
fixings.
4. Fit closing panel and secure with fixings.
5. Programme the ECU using TestBook.
FUEL DELIVERY SYSTEM - V8
DESCRIPTION AND OPERATION
19-2-1
FUEL DELIVERY SYSTEM - V8
DESCRIPTION AND OPERATION
Fuel delivery system
1 Fuel pressure regulator (hidden)
2 Schraeder valve
3 Fuel rail
4 Injectors
5 Engine block
6 Fuel feed pipe
7 Coarse filter
8 Fine filter
9 Fuel pump and fuel gauge sender assembly
FUEL DELIVERY SYSTEM - V8
19-2-2
DESCRIPTION AND OPERATION
Fuel tank and breather components (all
except NAS)
1 Fuel filler cap
2 Relief valve
3 Vent to EVAP canister
4 Tank breather connection
5 Fuel pump, regulator and fuel gauge sender
assembly
6 Seal
7 Locking ring
8 Fuel feed connection
9 Fuel gauge sender float
10 Fuel tank and breather assembly
11 Heat shield
12 Scrivet 2 off
13 Stud plate
14 Nut 2 off
15 Cradle
16 Bolt 2 off
17 Nut plate 2 off
18 Hose clip 2 off
19 Hose
20 Vent hose
21 Vent hose coupling
22 Hose clip 2 off
23 Hose
24 Filler tube
25 Liquid Vapour Separator (LVS)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст