Discovery 2. Manual — part 246
SEATS
REPAIRS 76-5-15
REPAIRS
Seat - front
$% 78.10.43.99
Remove
1. Disconnect battery earth lead.
2. Remove 3 screws and 1 trim clip securing
lower trim casing to seat.
3. Remove lower trim casing.
4. Remove cap from front seat belt lower
anchorage bolt.
5. Remove front seat belt lower anchorage bolt.
6. Remove 4 Torx bolts and nut securing front
seat to floor.
7. Lean seat forward to gain access to multiplugs.
SEATS
76-5-16 REPAIRS
8. Release pretensioner multiplug from seat
frame and disconnect.
9. Electrically operated seats: Disconnect 2
seat motor multiplugs.
10. Remove front seat.
Refit
1. Fit front seat in vehicle.
2. Electrically operated seats: Connect seat
motor multiplugs.
3. Connect pretensioner multiplug and secure to
seat frame.
4. Fit Torx bolts and nut securing front seat to floor
and tighten to 45 Nm (33 lbf.ft).
5. Fit front seat belt lower anchorage bolt to front
seat and tighten to 32 Nm (24 lbf.ft).
6. Fit cap to lower anchorage bolt.
7. Fit lower trim casing to seat and secure with
screws and trim clip.
8. Connect battery earth lead.
Seat - third row
$% 78.10.45
Remove
1. Manufacture a spring retainer bracket to the
dimensions given above.
2. Position third row seat in deployed position.
3. Remove the cup holder (where applicable).
SEATS
REPAIRS 76-5-17
4. Remove saddle bracket cover from lower rear
quarter to allow access to third row seat
securing bolts and nuts.
5. Remove top 2 bolts securing seat to lower rear
quarter panel.
6. Position the locally manufactured retainer
bracket across the seat mounting. Ensure that
the lugs on the end of the retainer fit below the
seat mounting bar, then partially fold the seat
so that the retainer bracket is held in position.
7. Remove lower 2 nuts securing seat to lower
rear quarter panel. The action of the spring will
now hold the retainer bracket in place.
8. Remove seat.
Refit
1. Ensuring that the retainer bracket is in position
on the spring, position third row seat to its
mounting studs.
2. Fit nuts securing third row seat to lower rear
quarter panel and tighten to 22 Nm (16 lbf.ft).
3. Remove the retainer bracket, fit bolts securing
third row seat to lower rear quarter panel and
tighten to 22 Nm (16 lbf.ft).
4. Fit saddle bracket cover to third row seat
securing bolts, fit the cup holder (where
applicable) and stow the seat.
SEATS
76-5-18 REPAIRS
Seat - rear
$% 78.10.48.99
This procedure is applicable to both rear seats.
Remove
1. Carefully pull carpet away from the rear seat
base to gain access to mounting brackets.
2. Remove 2 Torx bolts securing front of mounting
brackets to floor.
3. Fold rear seats fully forward.
4. Remove the 2 Torx bolts securing rear of
mounting brackets to floor.
5. Remove rear seat.
Refit
1. Position rear seat to floor in the fully folded
position. Fit Torx screws to rear of mounting
brackets and tighten to 45 Nm (33 lbf.ft).
2. Position rear seat in upright position. Fit Torx
bolts to front of mounting brackets and tighten
to 45 Nm (33 lbf.ft).
3. Position front carpet.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст