Discovery 2. Manual — part 769
DRIVING AIDS
REPAIRS 86-8-13
REPAIRS
Control unit (ECU) - parking aid
$% 86.54.10
Remove
1. Remove loadspace LH side trim casing access
panel.
2. Remove 2 bolts securing parking aid ECU
mounting bracket to body and manoeuvre ECU
and bracket assembly from behind trim casing.
3. Disconnect multiplug from ECU.
4. Remove 2 nuts securing ECU to bracket.
5. Remove ECU.
Refit
1. Fit ECU to mounting bracket and fit and tighten
nuts.
2. Connect ECU multiplug.
3. Manoeuvre ECU and mounting bracket
assembly behind trim casing, align, fit bolts and
tighten to 25 Nm (18 lbf.ft).
4. Fit access panel.
DRIVING AIDS
86-8-14 REPAIRS
Sounder - parking aid rear
$% 86.54.19
Remove
1. Remove loadspace LH side trim casing access
panel.
2. Remove 2 bolts securing parking aid ECU
mounting bracket to body and manoeuvre ECU
and bracket assembly from behind trim casing.
3. Disconnect multiplugs from parking aid ECU
and parking aid sounder.
4. Remove 2 nuts and bolts securing parking aid
ECU to bracket and remove the ECU.
5. Remove 2 screws securing parking aid sounder
to bracket and remove the sounder.
Refit
1. Fit parking aid sounder to the bracket and
secure with screws.
2. Fit parking aid ECU to the bracket and secure
with nuts and bolts.
3. Connect multiplugs to parking aid ECU and
parking aid sounder.
4. Manoeuvre ECU and mounting bracket
assembly behind trim casing, align, fit bolts and
tighten to 25 Nm (18 lbf.ft).
5. Fit and secure loadspace access panel.
DRIVING AIDS
REPAIRS 86-8-15
Sensor - parking aid - rear - inner
$% 86.54.23
Remove
1. Remove rear bumper assembly.
Bumper assembly - rear - from 03MY.
2. Remove 7 bolts and 5 screws securing closing
panel and remove panel.
3. Disconnect multiplug from sensor.
4. Release and remove sensor and sensor
housing.
Refit
1. Clean sensor location on bumper.
2. Fit sensor housing to bumper, ensuring lug on
housing is aligned with cut-out in bumper.
3. Fit and secure sensor to housing.
4. Connect multiplug.
5. Fit closing panel and secure with bolts and
screws.
6. Fit bumper assembly.
DRIVING AIDS
86-8-16 REPAIRS
Sensor - parking aid - rear - outer
$% 86.54.24
Remove
1. Remove tail lamp from bumper.
LIGHTING, REPAIRS, Lamp - tail/
2. Disconnect multiplug from sensor.
3. Release and remove sensor and sensor
housing.
Refit
1. Clean sensor location on bumper.
2. Fit sensor housing to bumper, ensuring lug on
housing is aligned with cut-out in bumper.
3. Fit and secure sensor to housing.
4. Connect multiplug.
5. Fit tail lamp.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст