Discovery 2. Manual — part 750
ALARM SYSTEM AND HORN
REPAIR 86-4-27
Sounder - battery backed-up (BBUS)
$% 86.77.13
Remove
1. Remove rear quarter lower casing.
REPAIRS, Trim casing - side - loadspace.
2. Remove nut securing BBUS to RH rear body
panel.
3. Disconnect multiplug and remove BBUS.
Refit
1. Position BBUS, connect multiplug and tighten
securing nut.
2. Fit rear quarter lower casing.
REPAIRS, Trim casing - side - loadspace.
Switch - bonnet
$% 86.77.20
Remove
1. Remove rubber cover from bonnet switch.
2. Disconnect multiplug, release switch retainers
and remove switch.
Refit
1. Position switch and connect multiplug.
2. Fit rubber cover to switch,
ALARM SYSTEM AND HORN
86-4-28 REPAIR
Receiver - alarm system - models with
sunroof
$% 86.77.31
Remove
1. Remove trim seal from rear sunroof.
2. Release sunroof switch and remove screw
securing headlining.
3. Remove 2 nuts securing receiver to roof panel,
disconnect multiplug and remove receiver.
Refit
1. Connect multiplug to receiver, fit to roof panel,
tighten nuts to 10 Nm (7 lbf.ft).
2. Fit and tighten screw securing headlining.
3. Fit sunroof switch
4. Fit sunroof trim seal.
5. Connect multiplug to receiver, fit to roof panel
and secure with nuts tighten to 10 Nm (7 lbf.ft).
Receiver - alarm system - models
without sunroof
$% 86.77.31
Remove
1. Release rear door upper trim finisher.
2. Remove 3 Torx bolts securing rear headrest,
remove headrest. Repeat operation on
opposite side.
3. Remove both 'D' post trim casings.
REPAIRS, Trim casing - 'D' post.
4. Release rear interior light lens, remove 2 nuts
to release light.
5. Release 2 studs securing rear headlining,
carefully lower lining.
6. Remove 2 studs securing alarm receiver.
7. Disconnect multiplug from alarm receiver and
remove receiver.
Refit
1. Connect multiplug to receiver.
2. Position receiver and secure with studs.
3. Position rear end of headlining, secure with
studs.
4. Position interior light fit and tighten nuts.
5. Fit interior light lens.
6. Fit both 'D' post trim casings.
REPAIRS, Trim casing - 'D' post.
7. Fit 3 Torx bolts securing headrest and tighten to
25 Nm (18 lbf.ft). Repeat operation on opposite
side.
8. Fit rear door upper finisher
M86 5632
M86 5762
ALARM SYSTEM AND HORN
REPAIR 86-4-29
Coil - passive immobilisation
$% 86.77.35
Remove
1. Remove steering column nacelle.
2. Release passive coil from steering lock.
3. Disconnect illumination bulb holder and
multiplug and remove passive coil.
Refit
1. Position passive coil, connect multiplug and
illumination bulb holder.
2. Fit passive coil to steering lock.
3. Fit steering column nacelle.
ALARM SYSTEM AND HORN
86-4-30 REPAIR
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст