Toyota Sequoia (2005). Manual — part 809
![](/vehicles/linovind/vere/fry/min.png)
BR0A5–05
F13329
N·m (kgf·cm, ft·lbf) : Specified torque
8.0 (82, 71 in.·lbf)
8.0 (82, 71 in.·lbf)
BR–58
–
BRAKE
REAR SPEED SENSOR
3225
REAR SPEED SENSOR
COMPONENTS
![](/vehicles/linovind/vere/fry/leloloze.png)
BR0A6–04
F13328
–
BRAKE
REAR SPEED SENSOR
BR–59
3226
REMOVAL
1.
DISCONNECT SPEED SENSOR CONNECTOR
2.
REMOVE SPEED SENSOR
(a)
Remove the 6 resin clips holding the sensor wire harness.
(b)
Remove the bolt and speed sensor from the axle carrier.
Torque: 8.0 N·m (82 kgf·cm, 71 in.·lbf)
BR0A7–07
BR–60
–
BRAKE
REAR SPEED SENSOR
3227
INSTALLATION
Installation is in the reverse order of removal (See page
HINT:
After installation, check speed sensor signal (See page
).
SR01S–06
–
STEERING
STEERING SYSTEM
SR–1
3228
STEERING SYSTEM
PRECAUTION
Care must be taken to replace parts properly because they could affect the performance of the
steering system and result in a driving hazard.
The SEQUOIA is equipped with an SRS (Supplemental Restraint System) such as the driver air-
bag and front passenger airbag. Failure to carry out service operation in the correct sequence
could cause the SRS to unexpectedly deploy during servicing, possibly leading to a serious
accident. Before servicing (including removal or installation of parts, inspection or replace-
ment), be sure to read the notices precautionary in the RS section.
When disconnecting the battery terminal, initialize the following system after the terminal is re-
connected.
System Name
See Page
Back Door Power Window Control System
When replacing the steering angle sensor, drive the vehicle straight ahead at a speed of 6.5 mph
(10.5 km/h) or more. Accordingly, zero point calibration of the steering angle sensor is per-
formed.
After performing ”Front wheel alignment adjustment”, clearing and reading the yaw rate & de-
celeration sensor zero point calibration data is necessary (See page
).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст