Toyota Sequoia (2005). Manual — part 717
![](/vehicles/linovind/vere/fry/belo.png)
LU08Z–10
B07332
New O–Ring
B07837
–
LUBRICATION
OIL COOLER
LU–23
2857
INSTALLATION
1.
INSTALL OIL COOLER
(a)
Clean the oil cooler contact surface on the cooler mount-
ing.
(b)
Place a new O–ring to the oil cooler.
(c)
Apply a light coat of engine oil on the threads and under
the head of the union bolt.
(d)
Install the oil cooler and plate washer with the union bolt.
Torque: 68.6 N·m (700 kgf·cm, 51 ft·lbf)
(e)
Connect the 2 oil cooler hoses to the oil cooler.
2.
INSTALL OIL FILTER (See page
)
3.
FILL WITH ENGINE COOLANT
4.
START ENGINE AND CHECK FOR ENGINE OIL
LEAKS
5.
CHECK ENGINE OIL LEVEL
![](/vehicles/linovind/vere/fry/myondo.png)
LU0IH–06
B17483
Piston
Connecting Rod Bearing
Connecting Rod Cap
Cylinder Block
Lower Main Bearing
Upper Crankshaft
Thrust Washer
Crankshaft
See page
1st 24.5 (250, 18)
2nd Turn 90
°
Upper Main Bearing
Lower Crankshaft
Thrust Washer
Main Bearing Cap
See page
1st 27 (275, 20)
2nd Turn 90
°
N·m (kgf·cm, ft·lbf)
: Specified torque
Non–reusable part
Oil Nozzle
9.0 (92, 80 in.·lbf)
LU–24
–
LUBRICATION
OIL NOZZLE
2858
OIL NOZZLE
COMPONENTS
![](/vehicles/linovind/vere/fry/tha.png)
LU0ID–05
B17484
–
LUBRICATION
OIL NOZZLE
LU–25
2859
REMOVAL
1.
REMOVE CRANKSHAFT (See page
2.
REMOVE OIL NOZZLE (WITH RELIEF VALVE)
Using a 5 mm hexagon wrench, remove the bolt and oil nozzle.
![](/vehicles/linovind/vere/fry/zveiglll.png)
LU0IE–05
B17485
LU–26
–
LUBRICATION
OIL NOZZLE
2860
INSPECTION
INSPECT RELIEF VALVE (OIL NOZZLE)
Push the valve with a wooden stick to check if it is stuck.
If stuck, replace the relief valve.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст